1 / 5

It should turn out like:

To “flow” from side to roof, select all lines indicated by red arrows using the ctrl key, select the follow me tool, and then click on the shaded area indicated by yellow arrow. It should turn out like:. Draw a rectangle, move it up, intersect faces, and trim away….

angus
Download Presentation

It should turn out like:

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. To “flow” from side to roof, select all lines indicated by red arrows using the ctrl key, select the follow me tool, and then click on the shaded area indicated by yellow arrow.

  2. It should turn out like:

  3. Draw a rectangle, move it up, intersect faces, and trim away…

  4. After selecting everything, right click, and soften/smooth. Area in circle results from bend that was too sharp…

  5. A few hints… • Limit the complexity of curves and follows. • Maximum number of large body pieces to 5 or 6 (hood, body, trunk, and fenders) • If you are following around a tight curve, make the extrusion shape smaller than the curve or it will never be smoothed out. • Simpler is better, read easier and faster.

More Related