1 / 14

CRO

CRO. Practical Guidelines for Using CRO. Panel of the CRO. Preliminary Adjustment. Before making any measurement, ground the CRO. Turn the “Position” knob so that the trace is at the centre (or at the bottom if required). Connection. Connect the CRO terminal to the component concerned.

ave
Download Presentation

CRO

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. CRO Practical Guidelines for Using CRO

  2. Panel of the CRO

  3. Preliminary Adjustment • Before making any measurement, ground the CRO. • Turn the “Position” knob so that the trace is at the centre (or at the bottom if required).

  4. Connection • Connect the CRO terminal to the component concerned. • Unearth the Y-input and select DC or AC mode as instructed. • The Earth terminal of the CRO should be connected to the Earth terminal of the circuit. The black terminal is the earth

  5. Adjustment of Sensitivity • Adjust the sensitivity so that the trace does not exceed the CRO screen. This knob should be turned fully clockwise.

  6. Adjustment of Timebase • Adjust the timebase so that one or two complete cycles can be observed on the CRO screen. This knob should be turned fully clockwise.

  7. Exercise 1 The following screen is seen on the CRO. What should we adjust in order to get an observable trace on the screen? A. Decrease the sensitivity B. Increase the sensitivity C. Decrease the speed of timebase D. Increase the speed of timebase

  8. Exercise 1 You are Wrong. Try Again. See Solution.

  9. Congratulations!You are right!

  10. Solution to Exercise 1 In this case, the trace exceed the upper and lower boundary of the screen. So, we should decrease the sensitivity of the Y-input.

  11. Exercise 2 The following screen is seen on the CRO. What should we adjust in order to get an observable trace on the screen? A. Decrease the sensitivity B. Increase the sensitivity C. Decrease the speed of timebase D. Increase the speed of timebase

  12. Exercise 2 You are Wrong. Try Again. See Solution.

  13. Congratulations!You are right!

  14. Solution to Exercise 2 In this case, not even one cycle was observed on the screen. So, the timebase must be too fast and we have to decrease the speed of the time base.

More Related