1 / 8

Build A PIC Microcontroller

Build A PIC Microcontroller. EET 250. End Goal. End Goal. Keypad. PIC16F917. Sensor. LCD Display. RS-232. Keypad. Assembly Steps. Simple PIC 16F917 40 PIN dip ( notch on left) Insert as shown Power and Ground +5V PINS 11, 32 GND PINS 12,31 Add .1UF cap between 11,12

beyla
Download Presentation

Build A PIC Microcontroller

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Build A PIC Microcontroller EET 250

  2. End Goal

  3. End Goal Keypad PIC16F917 Sensor LCD Display RS-232 Keypad

  4. Assembly Steps • Simple PIC 16F917 40 PIN dip ( notch on left) • Insert as shown • Power and Ground • +5V PINS 11, 32 • GND PINS 12,31 • Add .1UF cap between 11,12 • Add .1 UF cap between 32,31 • Jumper to +5V buss top to bottom • Jumper to GND Bus top to bottom • ICPD ( In Circuit Programmer Debug ) Interface for use with PICKIT2 • ( see attached schematic) • Use supplied 6 pin header • Single resistor /LED • !K with Red Led • hooked to PORTD RD0 • Test with Blink Code • Open blink.mcp • Select PICKUT2 • Make sure

  5. Close-up PIC Power and Ground Hook up .1UF and 4.7UF Bypass CAPS Power Bus (RED) Ground Bus (BLUE) Power Bus Extension Red to red Blue to blue ISDP Interface Resistor and LED 2.2K with High efficiency Red LED PIC Power and Ground Hook up .1UF Bypass CAP

  6. 40 PIN DIP

  7. PICKIT2 In Circuit Programmer/Debug HEADER MCLR --- PIN 1 1 2 VDD (+5V)-- PIN 11, PIN 32 3 VSS (GND)--- PIN 12, PIN 31 4 RB7--- PIN 40 Make sure to connect a 4.7K resistor to ground to each: pin 40 and pin 39 5 RB6--- PIN 39 6 Not Used

  8. Details

More Related