90 likes | 237 Views
2G BBULBE PASS Instructions-5 Replacement of Heater. Heater. Instructions. 1. Take off water inlet and outlet fittings. 2. Deflate spa. 4. Remove the air pipe. 3. Remove cord grip with screwdriver. Instructions. 5. Take out control box from spa pool. 6. Remove the foam.
E N D
2G BBULBE PASS Instructions-5 Replacement of Heater
Instructions 1. Take off water inlet and outlet fittings 2. Deflate spa 4. Remove the air pipe 3. Remove cord grip with screwdriver
Instructions 5. Take out control box from spa pool 6. Remove the foam 7.Loosen the screws on the top lid 8. Remove the top lid
Instructions Filter Transformer output Bubble Power input 2 PIN -Sensor Transformer input 3 PIN- water switch Heater
Instructions 9. Disconnect the wires 10. SPA power panel 12.Replace the heater 11. Remove the middle part of control box hull
Instructions 13. Assembly the middle part of control box hull 14. Connect the wires 16. Put on the foam 15. Put the top lid of control box
Instructions 17. Assembly the control box 18. Pull out the air pipe through spa tub 20. Screw back water inlet and outlet tightly 19. Connect the check valve with spa tub
Thanks for your listen respectfully Please give your valuable opinion!