1 / 22

Lecture 3 Elements of a Control System

Lecture 3 Elements of a Control System. Types of Control Systems. Open loop Process output has no effect on the system input Light switch to turn a light on or off Closed loop Process output determines how controlled input to the process changes Feedback control system: cruise control.

chapa
Download Presentation

Lecture 3 Elements of a Control System

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Lecture 3Elements of a Control System

  2. Types of Control Systems • Open loop • Process output has no effect on the system input • Light switch to turn a light on or off • Closed loop • Process output determines how controlled input to the process changes • Feedback control system: cruise control

  3. Parts of a Control System • A process; • A measuring instrument or device; • An error-detecting mechanism; • A controller; • A final control element or actuator. 3 & 4 are often combined together

  4. Process Control Diagram

  5. Constant Level Head Tank

  6. Simplified Ball-Mill Control System

  7. Complete B/M Control Typically, a complete grinding circuit control system includes several interacting Control Systems such as: • Mill Feed Rate Control • using power draw or CF flowrate or COF density or BMD sump level) • Ball Mill Water Addition Control • ratio control with respect to Mill Feed Rate • Ball Mill Discharge Sump Level Control • using CF pump speed • COF pulp density Control • using Mill Feed Rate and Total Water Addition • Cyclone Pressure or Cyclone Feed flowrate Control • using CF pump speed or Mill Feed Rate or a combination

  8. Control System Responses • Systems Analysis involves instituting a deliberate change in one of the system inputs • Set-Point Changes (loads held constant) • Load Changes (set-point held constant) • Change can be • Impulse • Step • Ramp • Sine Wave Transient Responses Steady-State Responses

  9. Desired Response • To a Set-Point Step Change • Immediately rising or lowering to new set-point • To a Load Step Change • Zero response (no change at all) • To a Set-point Sine Change • In-phase cycling with stable amplitude • To a Load Sine Change • Stable response at reduced amplitude

  10. Responses to a Set-Point Step Change Servo Operation

  11. Responses to a Load Step Change Regulator Operation

  12. Common Types of Controllers • Two-position controller (ON-OFF) • may be time-varying as well; • Integral Controller • Often called Proportional Speed-Floating or Reset • Proportional Controller; • Derivative Control • Often called Rate control

  13. Two-Position Controller

  14. Two-Position Controller (shifted)

  15. Integral Controller

  16. Integral Controller – sine wave

  17. Proportional Controller

  18. Proportional Controller – sine wave

  19. Derivative Controller

  20. Derivative Controller – sine wave

  21. Relative Cost of Controllers

  22. General Guidelines • On-Off is cheapest • Proportional is simplest but gives off-set • Integral is slowest, but eliminates off-set (reset) • Derivative is fastest, but off-set still occurs • Never use Derivative with noisy signals • PID is ultimate (fast response, no offset)

More Related