350 likes | 387 Views
Auxiliary Views. Incline Surface Oblique Surface. By B. Cowan & R .Cash. Incline Plane. Incline plane (surface) does not appear true size in any principal views such as the Front View, Side View, or Top View.
E N D
Auxiliary Views Incline Surface Oblique Surface By B. Cowan & R .Cash
Incline Plane • Incline plane (surface) does not appear true size in any principal views such as the Front View, Side View, or Top View. • You must draw an auxiliary view to show the true size of an incline plane (surface).
Incline Surface Right Side View Front View
Line Of Sight Projectors Perpendicular To Incline Surface Front View Right Side View Page 271
Reference Line Parallel To Edge View
Auxiliary View Of A Cylinder Page 278
Right Side View Front View
Use Offset Command To Set Off Reference Line
Project Center Line To Reference Line
Project Radius Of Cylinder
Use Ellipse Command To Draw Ellipse
Project Bottom Of Incline Plane
Use Trim Command To Trim Off Bottom Of Ellipse.
Partial Auxiliary Views Hidden Lines Short Break Lines Center Lines Projection
General Notes Lower Right Side Of Drawing. Above Title Strip or Title Block
Local Notes For Hole Size. (Other Hole Specified).
Break Line Partial Bottom View Auxiliary View Edge View Of Auxiliary View General Note Local Note Partial Side View Title Strip
Secondary Auxiliary View True Size of an Oblique Surface
Top View 4 Oblique Surface 1 3 2 4 3 1 Step 1 Locate Oblique Surface 2 Front View
Step 2 Locate True Length Lines Step 3 Draw Reference Lines perpendicular to projectors Reference Line True Length Lines Reference Line
3 4 2 1 4 3 1 3,4 2 Edge View 1,2
Reference Line Reference Line
4 1 True Size 3 4 3 2 1 2