Workbench project schematic

1. Workbench project schematic Place the new component on its source

3. Design Modeler Dimensions: mm

4. Axis Revolve Geometry: Sketch FD1: =180

5. Select XYPlan on the model tree than go to Sketching !

6. Revolve 2. Axis Sketch3 3. 180deg

7. Create named selections Surfaces Volume(FLUID) OUT CYL1 CYL2 SYM INL FLUID

10. Open ICEM

11. Create Body

12. Initialize blocking Create Block Initialize Block(s)

13. Split block Split Block Left click: positioning Middle click: apply Split Block

14. Delete block Delete Block Apply or middle click

15. Association Associate Associate edge to curve Show association I.

16. Association Show association I. Snap project vertices

17. Move vertex Move Vertex Move 4 vertexes to 60 deg position Move Vertex

18. Part mesh setup

19. Hexa sizes Surface

20. Pre Mesh params Pre-Mesh Update Sizes

21. Badelements 1.) Select: Blocking, Pre-Meshquality Cellswithbadquality 1.) Criterion: Angle

22. Split block Split Block Press “v” (all visible parts) then middle click to apply Ogrid Block Select Block(s)

23. Select these 6 parts! Ogrid block Select Face(s)

24. Check edges

25. Check Pre-Mesh

26. Refinement of themesh 1.) Select: Blocking, Edit Block Selectone of theradialedges 2.) Select: ModifyOgrid, Methode: RescaleOgrid Ofset: 0.5

27. Refinement of themesh 1.) Select: Blocking, Premeshparams 2.) Select: edgeparams 3.) Selectone of theradialedges 4.) Setnodenumberto 8 5.)Set spacing1: 0.2, ratio1: 1.2 6.)Methode: Bigeometric 7.)Enable: copyparmaters, toall parallel

29. Save project !

30. Create a FLUENT file 1.) Right clickonPre-mesh, selectConverttounstructmesh 2.) Save 3.) Clickon Output meshto ANSYS FLUENT

31. Set up the solver, check the boundary conditions!