270 likes | 372 Views
Halo Metallicity in NGC 891 An X-ray/UV Perspective. Edmund Hodges- Kluck Joel Bregman University of Michigan. How do baryons cycle in and out of galaxies, and how does this impact galaxy evolution? What happened to the “missing” baryons?
E N D
Halo Metallicity in NGC 891An X-ray/UV Perspective Edmund Hodges-KluckJoel Bregman University of Michigan
How do baryons cycle in and out of galaxies, and how does this impact galaxy evolution? • What happened to the “missing” baryons? • Are contemporary halos formed by infall from the IGM or galactic fountains?
High Z Low Z Metallicity is a distinguishing factor
QSO Absorption Lines • column density of halo metals • Dust Extinction/Scattering/Emission • dust type depends on Z • X-ray Emission • Z from simple thermal model How do we Measure Halo Metallicity?
Case Study: NGC 891 • Edge-on Milky Way analog • Nearby (10 Mpc) • Bright X-ray halo • Giant HI halo
Halo Metallicity from the X-rays • Clean test possible in the “outer halo” seen in 100 ks with XMM-Newton
Halo Metallicity from the X-rays • 1T fits to XMM+CXO spectra prefer Z < Zto 3σ (5σ joint fit)Hodges-Kluck+Bregman (2013)
Halo Metallicity from the UV • UV photons leaking out of the disk scatter off dust grains in the halo with metallicity-dependent spectrum
Galex and Swift UVOT sensitivity limited by foreground fluctuations (sky background is low) • Swift UVOT has persistent scattered-light artifacts, but these can be corrected by subtracting scaled templates in each filter
UV SED favors Milky Way-type dust over LMC or SMC dust, but need HST data to bracket UV bump (UVW1 filter has red leak)
QSO Absorption Lines • SOLAR (Bregman+2013) • Dust Extinction/Scattering/Emission • SOLAR (Rand+2011, Hodges-Kluck+2013, in prep) • X-ray Emission • SUBSOLAR (Hodges-Kluck+Bregman 2013) How do we Measure Halo Metallicity?
Hard to eject cold gas without ejecting hot gas, too • But, 109 M HI halo (Oosterloo+07) could not have cooled from the 3x108 M hot component at current cooling rate of <0.5 M/yr • Halo may not be in a steady state • X-rays could trace steady hot accretion; cooler gas might be from a galactic fountain or wind fallback Different Components?
Halo metallicity distinguishes between infall and galactic fountain scenarios • In NGC 891, cold gas seems to have solar metallicity, hot gas subsolar • Hot, cold gas may have different origin • New method in UV using Swiftmay be fruitful alternative to QSO absorption Summary
kT = 0.5 keV NH = 1021 cm2 100 10 Photon Flux (arbitrary) 1.0 0.1 Z = 0.1 Zʘ Z = 1.0 Zʘ 0.01 0.3 1.0 2.0 0.3 1.0 2.0 Energy (keV) Energy (keV) • Metallicity is a key indicator that is directly measurable in the X-rays • At CCD resolution, good S/N needed to distinguish spectral shape
From a fitting perspective, low metallicity results from flux below 0.6 keV The absorbing column in the outer halo is constrained well by other observations
Low metallicity not likely caused by systematics: • Unaccounted bkg • Abundance table • Absorption model • Calibration issues
But, the data also admit a 2-T model where both components have solar metallicity. This is in the outer halo
Two “reality checks” favor accretion • Limit on cooling rate from UV —O vi from Otte et al. 2003 indicates < 2-3 Mʘ/yr • Observed vs. expected scale height —Hobs measured assuming hydrostatic equilibrium—Hexp from cooling time
Clearly, the scattered light can bias a search for extended emission as objects of interest are usually centered on the chip
Bkg. Sub. Ring Count Rate [cts/s/pixel] Edge Bkg. Count Rate [cts/s/pixel]
UV – r color is too blue in most cases to be produced by an old stellar halo population But, a “stellar fountain” may be possible