170 likes | 328 Views
www.powerpointpresentationon.blogspot.com. ABOUT THE COMPANY CLIENTELLE DIESEL GENERATORS ENGINE ALTERNATOR INTRODUCTION TO AMF PANELS AMF PANELS LAYOUT OF PANEL MANUFACTURING PROCESS CONCLUSION & QUERIES. THE NAME OF THE COMPANY IS :- REALIBLE DIESEL ENGINEERS (P)LTD.
E N D
ABOUT THE COMPANY CLIENTELLE DIESEL GENERATORS ENGINE ALTERNATOR INTRODUCTION TO AMF PANELS AMF PANELS LAYOUT OF PANEL MANUFACTURING PROCESS CONCLUSION & QUERIES
THE NAME OF THE COMPANY IS :- REALIBLE DIESEL ENGINEERS (P)LTD. THE COMPANY WAS ESTABLISHED IN 1989 BY TWO EX-INDIAN NAVY ARTIFICERS :- Mr.A.K.VERMA & Mr.H.S.NEGI. THE COMPANY IS AN ISO – 9001-2000 CERTIFIED COMPANY WHICH MEANS THAT THE BEST OF QUALITY IS ASSURED. THE COMPANY IS BASED IN DELHI AND HAS ITS WORKS IN FARIDABAD.
TIL Ltd. NHPC Ltd. GE Motors Ltd. Airtel. Hero Honda Motors (P)Ltd. Escorts. Tata Tele Services Ltd. American Embassy. Flex Industries Ltd. AND MANY MORE……
A Generator basically consists of two main parts- a) The prime mover b) The alternator.
THE ENGINE BEING USED BY RELIABLE IS A 2 CYLINDER DIESEL ENGINE. IT HAS A RATING OF :- 16.8KW, 1500 R.P.M. THE ENGINE USED BY RELIABLE IS MANUFACTURED BY ESCORTS LTD. (FARIDABAD).
The alternator is manufactured by PRAKASH Ltd (FARIDABAD) and KIRLOSKAR Ltd. An alternator is an electromechanical device that converts mechanical energy to alternating current electrical energy. The specifications of the alternators are:- OUTPUT VOLTAGE: - 220 VOLTS. OUTPUT CURRENT: - 11 AMP. R.P.M.: - 1500 FREQUENCY: - 50 Hz.
TO SOLVE THE PROBLEM OF SHORTAGE OF POWER DIESEL GENERATORS ARE USED ON A VERY LARGE SCLAE. HOWEVER THE FREQUENCY OF THE CUTS HAS BECOME QUITE HIGH AND MANUAL STARTING AND SHUTTING OFF OF THE DG SETS BECOMES TROBLESOME AFTER A WHILE. SO WE HAVE DEVELOPED AMF PANELS.
OPERATION PRINCIPLE:-With the generator in 'Auto' mode, the incoming main is monitored continuously. If the mains voltage falls outside the preset limits, a 'mains failure' has occurred and the process of starting the generator set is initiated.
Sheet metal of 2mm thickness is taken and sent to the shearing machine for being cut into the required size. The sheet metal is then sent to the bending machine forbeing bent at the angles required. After the outer surface is ready the mounting plate is attached and holes are drilled for attaching the relays and other devices.
In today's world DG sets have become very common and due to the regular failure of the supply the use of AMF panels has become a must as switching on and switching off a DG set again and again at odd hours or even in industries is not feasible as it causes discomfort and delay.