1.1k likes | 2.25k Views
Mr. Morgan HVAC/R Instructor . Section 608 Certification Pre-Test. CORE. Ozone in the stratosphere above the earth consists of;. A: molecules containing 3 oxygen atoms. B: molecules of 2 oxygen atoms. C: radioactive particles. D: pollutants that have risen from ground level.
E N D
Mr. Morgan HVAC/R Instructor Section 608 Certification Pre-Test
Ozone in the stratosphere above the earth consists of; A: molecules containing 3 oxygen atoms. B: molecules of 2 oxygen atoms. C: radioactive particles. D: pollutants that have risen from ground level.
Which compounds have the highest ozone depletion potential (ODP)? A: HCFCs. B: HFCs. C: CFCs. D: All are equal.
Which atom of the CFC molecule causes ozone depletion? A: Fluorine. B: Chlorine. C: Carbon. D: Hydrogen.
What characteristic(s) of CFCs make them more likely to reach the stratosphere than most other compounds containing chlorine? A: CFCs neither dissolve in water nor break down into compounds that dissolve in water, so they do not rain out of the atmosphere. B: CFCs are lighter than other chlorine compounds, making it easier for them to float upward when released. C: CFCs are stored under pressure, causing them to jet upward when released. D: CFCs are attracted to ultraviolet radiation.
Each chlorine atom in the stratosphere can destroy ______ ozone molecules. A: 1 B: 3 C: 100,000 D: Chlorine is not the element in refrigerant that harms ozone.
HCFC refrigerants are; A: more harmful to stratospheric ozone than CFCs. B: as harmful to stratospheric ozone as CFCs. C: less harmful to stratospheric ozone than CFCs. D: not harmful to stratospheric ozone.
What effects can ozone depletion have on the environment? A: Reduced crop yields. B: Reduced marine life. C: Increased ground-level ozone. D: All of the above.
The Clean Air Act; A: calls for the phase out of CFC/HCFC production. B: prohibits venting of CFC and HCFC refrigerants and their substitutes. C: requires EPA to set standards for recovery of refrigerants prior to appliance disposal. D: All of the above.
An award of up to what amount may be paid to a person supplying information that leads to a penalty against a technician who is intentionally venting? A: $5,000. B: $10,000. C: $25,000. D: $50,000.
Before you dispose of any appliance containing a CFC or HCFC refrigerant, you must; A: recover the refrigerant. B: purge the appliance with nitrogen. C: flush the appliance with R-11. D: seal the appliance so no refrigerant can escape
Service technicians who violate Clean Air Act provisions: A: May be fined. B: May lose certification. C: May be required to appear in Federal court. D: All of the above.
Which of the following CFC or HCFC refrigerant releases is considered a violation of the prohibition on venting? A: Release of "de minimis" quantities in the course of making good faith attempts to recapture and recycle or safely dispose of refrigerant. B: Release of mixtures of nitrogen and refrigerant that result from adding nitrogen to a fully charged appliance to leak-check the appliance. C: Refrigerants emitted in the course of normal operation of an appliance. D: Refrigerants emitted when connecting or disconnecting hoses to charge or service an appliance.
Some state and local governments may establish laws that; A: follow the Clean Air Act/EPA regulations. B: are not as strict as the Clean Air Act/EPA regulations. C: contain stricter regulations than the Clean Air Act / EPA regulations. D: Both "A" and "C".
Chlorofluorocarbons (CFCs) and hydrochlorofluorocarbons (HCFCs) have which of the following in common? A: They have the same ozone depletion potential. B: They both contain hydrogen. C: They must be recovered before opening or disposing of appliances. D: They have the same saturation pressure at 70°F.
The oils that will be employed with most of the HFC-134a refrigeration applications are; A: esters. B: alkylbenzenes. C: whale oils. D: All oils are compatible with HFC-134a.
Which of the following is an approved "drop-in" service replacement for R-12? A: HFC-134a B: HFC-125 C: CFC-502 D: None of the above
Refrigerant entering the compressor of a refrigeration system is a; A: liquid B: sub-cooled liquid C: sub-cooled vapor D: superheated vapor
Manufacturers often color code the exterior of gauges. On a typical gauge manifold set, the high pressure gauge is color coded; A: green B: yellow C: blue D: red
Removing refrigerant in any condition from a system and storing it in an external container without necessarily testing or processing it in any way defines; A: recycling. B: recovering. C: reclaiming. D: restoring.
If a system will not hold a vacuum after it has been evacuated, then; A: the system is ready to be charged. B: the system has been adequately evacuated. C: the system may be leaking. D: an expansion valve is clogged.
Long hoses between the unit and the recovery machine should be avoided as they cause; A: excessive pressure drop. B: increased recovery time. C: increased emissions. D: All of the above.
The piping connection to the vacuum pump should be; A: as short in length and as large in diameter as possible. B: suitably sized to connect to a gauge manifold. C: coiled and taped together. D: colored red or blue to meet codes.
Why shouldn't technicians use oxygen or compressed air to pressurize appliances to check for leaks? A: When mixed with compressor oil or some refrigerants, either oxygen or compressed air can cause an explosion. B: Leaking oxygen or compressed air is difficult to detect. C: The pressures produced by either oxygen or compressed air are not acceptable. D: Neither oxygen nor compressed air mix well with refrigerants.
Under what conditions may you use a disposable cylinder to recover refrigerant? A: When the system contains the same refrigerant as the cylinder. B: When the system contains less than 10 lbs. of refrigerant. C: Only in an emergency. D: Never.
How should refrigerant cylinders be positioned when they are shipped? A: Inverted. B: Upright. C: Horizontally. D: Stacked.
EPA regulations include which of the following in the definition of a "small appliance"? A: Products manufactured, charged and hermetically sealed in a factory. B: Products having 5 pounds or less of refrigerant. C: Products with compressors under 1/2 horsepower. D: Both "A" and "B".
Recovery equipment used during maintenance, service or repair of small appliances must be certified by an EPA-approved laboratory if manufactured AFTER: A: July 1, 1992. B: July 1, 1993. C: May 13, 1993. D: November 15, 1993.
The sale of CFC and HCFC refrigerants is; A: banned. B: limited by law to equipment owners. C: allowed only if there is proof of need. D: restricted to technicians who are EPA certified in refrigerant recovery.
When servicing a small appliance for leak repair; A: It is mandatory to repair the leak within 30 days. B: It is mandatory to repair the leak only when 35% of the charge escapes within a 12 month period. C: It is not mandatory to repair the leak but do so whenever possible. D: Both "A" and "B".
If EPA regulations change after a technician becomes certified; A: the technician certification is "grand fathered" for one year to allow time for re-certification. B: it will be the technician's responsibility to comply with any future changes in the law. C: a new certification test must be taken to be re-certified. D: Both "A" and "C".
EPA appliance sealed system with a non-operating compressor if technicians are using rules require capture of 80% of the refrigerant from a small; A: a system-dependent (passive) process. B: a self-contained (active) process. C: Either recovery process. D: Neither recovery process.
Which of the following is NOT a Type I appliance? A: An MVAC-like system that holds three pounds of R-12. B: A water cooler that holds 13 ounces of R-12. C: A food freezer that holds 22 ounces of R-22. D: A dehumidifier with seven ounces of R-500.
When checking for non-condensables inside a recovery cylinder, why should the technician allow the temperature of the cylinder to stabilize to room temperature before taking a pressure reading? A: To prevent safety valves from purging refrigerant. B: It is a quick method of determining refrigerant level inside the tank. C: Comparisons to a pressure-temperature chart are only valid if both the pressure and temperature of the refrigerant are stable and known. D: A temperature reading alone is enough to determine refrigerant quality.
When recovering refrigerant into a non-pressurized container from a refrigerator with an in operative compressor; A: it is necessary to heat the compressor and strike it with a rubber mallet. B: it is only necessary to recover as much refrigerant as will naturally flow out of the system. C: it is not necessary to recover since the refrigerant is probably contaminated. D: it is necessary to chase refrigerant from the oil with pressurized dry nitrogen.
When installing any type of access fitting onto a sealed system; A: the fitting should be leak tested before proceeding with recovery. B: it is not necessary to leak test an access fitting. C: the fitting need not be leak tested until the total repair is completed. D: the system must be pressurized with dry nitrogen before leak testing can beattempted.
When R-500 is recovered from an appliance, it; A: can be mixed with either R-22 or R-12 during the recovery process, since R-500 is actually a mixture of the two refrigerants. B: can be mixed with R-12 but not R-22 during the recovery process. C: need not be recovered since R-500 is not one of the refrigerants covered by the Clean Air Act. D: must be recovered into its own recovery vessel that is clearly marked to ensure that mixing of refrigerants does not occur.
A standard vacuum pump designed specifically for evacuation and dehydration can; A: be used alone as a self-contained (active) recovery device. B: never be used as a recovery device in combination with a pressurized container. C: be used alone as a substitute for any recovery device. D: be used alone as a system-dependent (passive) recovery device.
Using the system-dependent (passive) recovery process, which condition requires the accessing both the high and low side of the system for refrigerant recovery? A: When there is a leak in the system. B: When the compressor operates normally. C: When the compressor only runs at half speed. D: When the compressor does not run.
Which of the following refrigerants must be recovered with equipment currentlyregulated by the equipment certification requirements of the EPA under Section 608? A: Sulfur dioxide. B: Methyl chloride. C: Methyl formate. D: R-12.
The system-dependent (passive) recovery process for small appliances; A: never needs the use of a pump or heat to recover refrigerant. B: must use a pressure relief device when recovering refrigerant. C: captures refrigerant in a non-pressurized container. D: can only be performed on a system with an operating compressor.
Before beginning a refrigerant recovery procedure it is ALWAYS necessary to; A: allow the appliance to stabilize at room temperature. B: know the type of refrigerant that is in the system. C: remove the appliance to an outdoor location. D: disconnect the appliance from its power source.
If a reclamation facility receives a tank of mixed refrigerant, they may; A: refuse to process the refrigerant and return it at the owner's expense. B: agree to destroy the refrigerant, but typically a substantial fee is charged. C: resell the refrigerant for reuse in its current state. D: Both "A" and "B".
It is generally recommended that piercing-type valves be used on which of the following tubing materials? A: Copper. B: Aluminum. C: Steel. D: Both "A" and "B".
When filling a graduated charging cylinder, refrigerant that is vented off the top of the cylinder; A: need not be recovered. B: must be recovered. C: is considered a "de minimis" release. D: None of the above.
A storage cylinder of recovered R-22 at normal room temperature (about 75 degrees F), in the absence of non-condensables, will be pressurized to; A: 250 psig. B: 200 psig. C: 175 psig. D: 130 psig.
A storage cylinder of recovered R-500 at normal room temperature (about 75 degrees F), in the absence of nun-condensables, will be pressurized to; A: 30 psig. B: 75 psig. C: 95 psig. D: 120 psig.
Refrigerants (i.e., R-12, R-22, R-500, etc.) in large quantities can cause suffocation because; A: they smell strong and make breathing difficult. B: they are lighter than air and cause dizziness. C: they are heavier than air and displace oxygen. D: they sting the nose and cause sneezing.