1 / 8

Mock CCID-41 Fit Checks

Mock CCID-41 Fit Checks. MIT/LL REXIS/OBF Telecon 5/8/13. General Cosmetics. One CCD was cracked on delivery This doesn’t impact what we’re doing, but we did want to make sure that you knew this Wirebonds look great under a microscope, particularly the ones near the embedded RTD

harva
Download Presentation

Mock CCID-41 Fit Checks

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Mock CCID-41 Fit Checks MIT/LL REXIS/OBF Telecon 5/8/13

  2. General Cosmetics • One CCD was cracked on delivery • This doesn’t impact what we’re doing, but we did want to make sure that you knew this • Wirebonds look great under a microscope, particularly the ones near the embedded RTD • CCID-52 instead of CCID-41?

  3. Intra-Package Alignment • Evaluation is only qualitative at this stage • Working on setting up quantitative evaluation within the next week • Alignment of chips perpendicular to flexprints looks very good on all four CCDs • Flexprints appear to have some rotational misalignment • Not enough to affect connection to REXIS electronics, but would appear to affect wirebond length • 1 is flush up against the CCD, 2 have the gap increasing from left to right, 1 has the gap increasing from right to left No gap present Gap increases from left to right

  4. Intra-Package Alignment • Alignment of chips parallel to flexprints looks good on 3 of 4 CCDs • Cracked CCD appears to be closer to the edge of the package than the others Uncracked CCD Cracked CCD

  5. Inter-Package Alignment • Clearance between CCDs and inside edges of detector assembly looks good • Aiming for at least 1mm all the way around the array Adequate (>1mm) clearance Hard to tell but there is clearance here

  6. Inter-Package Alignment • One CCD appears to have the tee too far from the flexprint and possibly off-center • While a concern, the other CCDs look fine • Any thoughts on what happened with this one? • N.B.: Gap between CCDs along X and along Y are not the same due to the geometry of the CCID-41 active area and framestore Difficult to see but this CCD appears to be closer to the assembly edge CCD is not up far enough

  7. Shipping Containers for EM CCDs • We have many old mounting fixtures that would be appropriate for housing EM CCDs • Keith mentioned LL may have boxes that would mate to these fixtures? • We might have extra boxes • Do we need to give LL anything?

  8. Path Forward • Issues to address before EM CCD assembly can begin • Moving die inboard off package front edge • Flexprintrotational misalignment with respect to CCD die • Tee misalignment • Are any of the above issues with the assembly process or are they within fabrication tolerances? • If none of the above can be addressed at LL, we may be able to adjust our design to accommodate but this is not ideal • Is the wirebond length OK? • Shipping containers/fixtures for CCDs

More Related