1 / 16

Chp-3-Strength Analysis of Beams According to ACI Code

Chp-3-Strength Analysis of Beams According to ACI Code.

infinity
Download Presentation

Chp-3-Strength Analysis of Beams According to ACI Code

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Chp-3-Strength Analysis of BeamsAccording to ACI Code From the early 1900s until the early 1960s, nearly all reinforced concrete design in the UnitedStates was performed by the working-stress design method (also called allowable-stress design orstraight-line design). [n this method, frequently referred to as WSD, the dead and live loads to besupported, called working loads or service loads, were first estimated. Then the members of thestructure were proportioned so that stresses calculated by a transformed area did not exceed certainpermissible or allowable values.

  2. equivalent rectangular block

  3. [ C = T ] Mn , is defined as the theoretical or nominal resisting moment of a section. Mu is factored load, φ is strength reduction factor.

  4. The usable flexural strength[or ultimate moment capacity]

  5. p. 654 for fy = 40,000 psi, and f’c = 4,000 psi

  6. BALANCED SECTIONS, TENSION-CONTROLLED SECTTONS and COMPRESSTON-CONTROLLED OR BRITTLE SECTIONS

  7. Please continue to read page 71 be able to interpret Figure 3.5 for comprehension of :

  8. failure can occur in very lightly reinforced beams. If the ultimate resisting moment of the section is less than its cracking moment, the section will fail immediately when a crack occurs. This type of failure may occur without warning. To prevent such a possibility, the ACI (10.5.1) specifies a certain minimum amount of reinforcing that must be used at every section of flexural members where tensile reinforcing is required by analysis, whether for positive or negative moments. In the following equations, bw, represents the web width of beams.

More Related