Review of Human Factors in Queensland Mining incidents

1. Review of Human Factors in Queensland Mining incidents The HFACS-MI project Trudy Tilbury, Safety and Health

2. What is human factors and why use it in Mining Introduction to HFACS-MI Main findings from HFACS-MI Analysis QME strategy Questions Points covered today

3. A general definition of Human Factors “Human factors is the multi-disciplinary science that applies knowledge about the capabilities and limitations of human performance to all aspects of the design, manufacture, operation, and maintenance of equipment and systems”. (ATSB, adapted)

4. Human Factors = evidence on people Focus is on what people can and can’t do in the real world of work rather than a design/ engineering view of people Some systems, and the equipment used in them, are developed without information on the end users, or based on (sometimes) outdated standards

5. Most safety management systems do not address human error, for example: Ignoring potential human error/human factors completely - especially in risk assessments. Using training as a control without understanding that training will not have an effect on skill based (autopilot) errors or violations (adapted from HSE, Human Factors) Human Factors gaps

6. Introductionto HFACS-MI

7. HFACS is a ‘taxonomy’ or classification system looking at errors (unsafe acts), unsafe leadership and organisational factors HFACS-MI (developed by Clemson University specifically for use in Queensland Mining) is based on the work of James Reason The lowest level of errors (unsafe acts that happen directly before an incident) are skill based, decision and perceptual errors Introduction to HFACS-MI

8. HFACS-MI

9. Human error in the HFACS-MI model A very common error is a ‘routine disruption error’ or autopilot error (skill based error in the Reason or HFACS model) These errors happen when we’re on autopilot and we miss something (like a turn off for home). These errors are made by those who are fully competent or ‘unconsciously competent’

10. Human error in the HFACS model Another common error is a “decision error” These errors are the ones where you have a plan, but take the wrong action usually because you don’t have all of the information or knowledge, or because of previous experience.

11. Human error in the HFACS model Key point from HFACS model and Reason Error at lower levels can be influenced or caused by decisions and ‘latent’ errors within the organisation or system. It is important to trace these errors back to the actual root cause .

12. Errors influenced by higher levels Li and Harris, 2006

13. HFACS-MI analysis of Unsafe Acts for 500+ Qld Mining incidents from 2004 HFACS-MI Results

14. Data used in analysis

15. Unsafe Acts 95% of cases identified at least 1 unsafe act Skill-based Errors most identified (50%) Perceptual Errors and Violations represent <10% of codes identified

16. Skill-based Errors (consciously competent, routine disruption) Attention failures most identified (32%) Occur when operators are focused on multiple things at once. Technique errors refer to how things are done (24%) PPE/Tool/Equipment errors (14%)

17. Decision Errors Procedural errors (29%): Incorrect application, applying incorrect procedure, lack of knowledge on correct procedure Situational assessment (22%): Identification of hazards Risk assessment (19%): using appropriate risk assessments, JSA, Take 5, etc.

18. Where could HFACS-MI ‘fit’ in mining?

19. Incompatible controls

20. HFACS is a ‘taxonomy’ or classification system, not an investigation tool or system Primary focus for the QME working group is to translate HFACS-MI findings into current systems, including investigations Primary focus for QME Ergonomist is to improve understanding of human factors and human error via website, seminars HFACS-MI Strategy

21. Using human factors principles in mining investigations

22. Butchers Hill • New equipment • No formal lockout/tagout Human factors issues (additional to safety) Communication Design End of shift on a hot day

23. Improving awareness of human factors

24. Questions? Trudy Tilbury A/Senior Principal Ergonomist/Principal Human Factors Advisor 07 4760-7412