630 likes | 854 Views
Resistive Magnetohydrodynamics. Liu Jian 2006.10.31. Email: ljssspku@gmail.com Mobile Phone: 138 1000 1317. Outline of This Chapter. Introduction Magnetic relaxation and reconnection Resistive instabilities Magnetic field generation The solar wind MHD shocks.
E N D
Resistive Magnetohydrodynamics Liu Jian 2006.10.31 Email: ljssspku@gmail.com Mobile Phone: 138 1000 1317
Outline of This Chapter • Introduction • Magnetic relaxation and reconnection • Resistive instabilities • Magnetic field generation • The solar wind • MHD shocks
From Ideal MHD to Resistive MHD The dissipative terms are of higher differential order than the non-dissipative terms ,so even a very small amount of dissipation can lead to solutions which are significantly different from those of ideal MHD.
Lundquist Number • definition: • is the characteristic times for resistive diffusion and convection. • is the Alfvén transit time. • When S is large enough ,we can take on the ideal MHD approximation. • sunspot data (see table5.1 on Page 141) : • Why?
Explanation of The Problem • There must be some much faster mechanism. • The large S may not caused by the entirely negligible resistivity ,but compared with L the length scale of the region considered is very small. • In this case ,ideal MHD is valid for most of the plasma ,but in the narrow boundary layers we must apply resistive MHD. • Within such regions, topological changes take place on a time scale intermediate between diffusion time and Alfvén time, which enable the system to arrive at a lower energy state.
Magnetic Reconnection • neutral sheet :the plane in which B=0. • field is slowly varying with y, decreasing in magnitude, reversing sign, and then increasing again. • field line define the x-axis • current j is parallel to the z-axis • Lorentz force j×B acts downwards for y>0, and upwards for y<0.
Magnetic Reconnection • In ideal MHD, either these forces are opposed by a plasma pressure gradient maintaining equilibrium or plasma and field lines will move together towards the y=0 plane until these forces are balanced. • However, if we introduce finite resistivity, no matter how small, the field is no longer frozen in to the plasma. The field lines will move across the plasma and this allows to breaking of the field lines with reconnection to lines of opposite polarity.
Magnetic Island • The addition of resistivity allows magnetic field lines to break and reconnect so that they are no longer frozen into the fluid as described in Chapter4. • This has a profound effect on the MHD model. • With resistivity, the magnetic field tends to break up into a number of thin filaments called magnetic islands which thread their way through the plasma. • Since heat flows rapidly along field lines, one of the direct effects of this island structure is to enhance transport across the plasma.
Magnetic Island • reconnection may happen at various points along the neutral lines, give rise to so-called magnetic islands. • The null-points of the magnetic field define O-points at the axes of the magnetic islands, and X-points at the intersections of the separatrix.
The topological change takes place because the magnetic energy associated with the magnetic islands is less than that in original MHD equilibrium configuration. • Imagine the field lines as stretched strings: the tension in them has been reduced because breaking and reconnecting allows them to contract around the island axes.
Magnetic Helicity :K • definition: • It provides a measure of the complexity of the magnetic field topology.(P103,why? how?) • see derivation details in《等离子体理论基础》,胡希伟,Page 14
Taylor’s Hypothesis • Woltjer showed that the helicity K of ideal plasma is conserved for every volume enclosed by a flux surface. • Taylor’s hypothesis states that only the helicity associated with the total volume of the plasma is conserved. • It means that the final state of the plasma is largely independent of its initial conditions.
Driven Reconnection • spontaneous reconnection and driven reconnection. • Sometimes (i.e. in plasmas collision—in solar flares and when the solor wind strikes the Earth’s magnetosphere), driven reconnection may occur. • Using Lundquist number as an index of the spontaneous reconnection rate:
According to mass conservation Under steady state conditions, the rate at which magnetic flux is convected towards the current sheet by the plasma flow is balanced by the rate of ohmic dissipation,so that From these two equations, we can get Thus
Theory Development • Sweet-Parker model: developed by Parker(1963) • The Sweet-Parker reconnection rate is much too slow to characterize some faster mechanism. • Petschek(1964) reasoned that the magnetic fields would meet at a relatively narrow apex, rather than across the entire region envisaged in the Sweet-Parker model, and found a maximum reconnection rate:
Resistive Instabilities • It might be expected that the addition of resistivity or viscosity or heat conductivity to the ideal equations would only reduce the growth rate of instabilities because resisitivity would dissipate away electrical currents, viscosity would damp out any sheared velocities, and heat conductivity would diminish local thermal gradients which could provide a source of free energy. • However, it is important to realize that the addition of dissipation can produce new instabilities by removing constraints from the ideal equations and, thereby, making states of lower energy accessible to the plasma.
Resistive Instabilities • The ability of a plasma, through magnetic reconnection, to reach lower energy states means that the ideal MHD stability needs re-examination. • Allowing for variable resistivity, we can get: Thus we can introduce the driving term for one of the resistive instabilities.
Resistive Instabilities • The relaxation of constraints can also make existing instabilities grow faster. • The growth rate of resistive instabilities is determined by how fast the magnetic field lines can be broken, viewed as a kind of throttling process, balanced against the driving forces and inertial effects. • It is an important feature of these instabilities that the field lines need to be broken only in a thin boundary layer within the plasma.
Resistive Instabilities • Since the dissipation process is governed by a diffusion equation, the time scale for the throttling process is determined by the width of the boundary layer squared divided by the diffusion coefficient. • If the boundary layer thickness were comparable to the radius of the plasma, the result would be resistive diffusion which proceeds on a very slow time scale compared to most MHD instabilities. • If the boundary layer were too thin, inertial effects would limit the growth rate of the instability.
Resistive Instabilities When all the effects are balanced, it turns out that the resistive instabilities grow on a time scale much slower than the Alfvén transit time scale and much faster than the typical diffusion time scale. There are three kinds of instabilities whose growth times much smaller than but much greater than • tearing mode (spontaneous instability) • gravitational interchange mode (driven instability) • rippling mode (driven instability) see table 5.2 on P156
Rayleigh-Taylor Instability • Resistive g mode and rippling mode has similar mechanism with Rayleigh-Taylor instability.
Tokamak Instability • The tearing mode also makes its appearance in cylindrical and toroidal plasmas, in which the resonant surfaces occur at the mode rational surfaces. (P158 Fig.5.9) • Tearing mode instabilities are believed to be the source of Mirnov oscillations, which are magnetic fluctuations occurring during the current rise in tokamaks. (P159 Fig.5.10)
Sawtooth Oscillations • Another instability, observed in the soft X-ray emission from tokamaks. • For example, the m=1 kink mode occurring in the centre of the plasma. • The outer region of the plasma show the inverse pattern, indicating that temperature changes in the outer plasma compensate those occurring in the central plasma due to the instability.
Development of Sawtooth • Slow build-up process: • Inner region of plasma is hotter. • conductivity σ=1/η increases with temperature • current I increases • ohmic heating increases, which makes the inner region hotter hotter • this leads to an unstable concentrating of current in the centre of plasma • the poloidal magnetic field increases • safety factor q falls
Development of Sawtooth • Sudden fall process • q<1 allowing the q=1 surface near the axis • m=1 instability develop at the q=1 suface • see Page161 Fig.5.12 • reconnection accurs • q>1 islands displace the hot island • hot island slowly decays and disappears by thermal conduction to the cooler plasma • the procedure is repeated
Disruptive Instability • It can lead to the collapse of the plasma current. • Principal characteristics: rapid broadening of the current profile with consequent decrease in the poloidal field, followed by a loss of thermal energy from the plasma to a degree that quenches the discharge. • Magnetic surfaces are destroyed by tearing modes with different helicities at different resonant surfaces. • It is the least well understood of the tokamak instabilities.
Disruptive Instability • Observation indicate that m=2 tearing mode is crucially involved. • m=2 mode triggers the precursor phase (Page162) • non-linear interaction with m=1 or m=3 modes involved • the growth in amplitude over a period of about 10ms triggers the fast phase in which the central temperature collapses and the radial current profile flattens in a time of the order of 1ms.
Magnetic Field Generation • Magnetic field of the Universe ranging in magnitude from background level to neutron stars. (vast) • Where do magnetic fields come from??? • trapped in the original formation of galaxy, trapped from the interstellar matter. • How the observed magnetic fields of stars and planets are sustained?---------this is a long-standing and challenging problem in MHD.
Magnetic Field Generation • There are two possible mechanisms by which magnetic fields may be regenerated. (like dynamo or battery) • One requires some initial field on which the fluid motion can act. • The other one doesn’t have the requirement • suggested by Biermann (1950) • cannot generate sufficient strong fields • if all other fails, it guarantees a seed field for stars and galaxies
The Kinematic Dynamo • use the kinetic energy in flow field • kinematic dynamo problem: try to device a flow field which will maintain a magnetic field against resistive decay. It involves too many equations to be analyzed. • anti-dynamo theorem: in 1934,Cowling showed that a steady, axisymmetric magnetic field cannot be maintained. • The proof of Cowling’s theorem can be extended to include an azimuthal component of the magnetic field
The Kinematic Dynamo • existence theorems: Herzenberg(1958) and Backus (1958) proved existence theorems for possible dynamo mechanisms for steady and oscillating fields respectively. • This leads to rapid development of other dynamo models. • The kinematic problem is now broadly understood except for its mathematical complexity.
Stretch-twist-fold cycle • Suggested originally by Zel’dovich in 1972 • Stretch-twist-fold cycle (see Fig 5.15 on P165) • Can obtain a field of twice the original strength through the fixed loop C. • It illustrates how the field strength may be increased from an arbitrarily low level. • It’s necessary to explain what kind of a flow might realistically produce this effect. • The answer lies in the combination of α-effects and Ω-effects.
Ω-effect • Ω denotes the rate of angular rotation of a conducting sphere. • Ω varies with distance from the axis of rotation. • The differential rotation rate arises when convection currents are subjected to a combination of buoyancy and Coriolis forces. • By conservation of angular momentum, descending fluid elements increase their rate of rotation.
A field line passing through the rotating sphere is wound around the axis of rotation rather than simply being carried around, as would be the case if the rotation rate was uniform. • Thus, a purely poloidal field can create a toroidal field component.
α-effect • The α-effect creates a poloidal component from a purely toroidal field. • The book gives an example to explain that a flow can deform a straight magnetic field line into a helix. • In ideal MHD, j paralel to B produces a helical field.While the electromotive force j×B gives rise to a current component perpendicular to B. • Only when the effect of finite resistivity shifts the phase of the magnetic field perturbation b relative to j, that a space average < j×B > leads to a current component parallel to B.
Combined αΩ-mechanism • Thus the combined αΩ-mechanism comprises a regenerative cycle. • It is now widely accepted that it is by this cycle that the magnetic fields of the Earth and Sun are maintained. • At present, the physical existence of fast dynamos has not been conclusively established.
The Solar Wind • The continual streaming of plasma from the sun’s surface. • The solar wind extends the solar plasma to the Earth and well beyond. (50-100 AU) • It is the cause of geomagnetic storms and the shape of comet tails. • Parke(1958) showed that no dydrostatic equilibrium between the solar corona and interstellar space was possible and that non-equilibrium is what gives rise to a supersonic low density flow which is the solar wind.
The Solar Wind • The solar wind is composed largely of protons and is permeated by a magnetic field. • Solar wind characteristics (see table 5.3 on page 170) • Because of the Sun’s rotation, the magnetic field is twisted into a spiral. It exhibits a complex structure attributable in part to the admixture of open and closed magnetic structures at the Sun’s surface. • In a general sense open magnetic structures are favourable to the generation of the solar wind while closed structures oppose it.
MHD Shocks • Supersonic flow gives rise to the generation of shock waves.
the sound speed is greatest at the peak of a finite amplitude wave, so the wave-front steepens. • Since the wave-front deepens, the dissipative effects become stronger. the dissipative effects are proportional to gradients in the fluid variables. • When the convective steepening is counter-balanced by the dissipative flattening, a steady profile is achieved. • The smaller the coefficients of dissipation, the more nearly the shock wave approaches a vertical discontinuity.