Super Star Tracker

1. Super Star Tracker ISAL Study 28 January - 8 February 2002

2. Get a good handle on mass/power/cost/size for input into an IMDC study for SI or MAXIM Pathfinder, where 30 microarcsec line-of-sight knowledge is needed. At least better than the WAG we have made in the past IMDC runs Define “other” requirements- jitter, thermal,.. Understand the scaling laws to make this eventually work for a more complex mission needing 30 nanoarcsec line-of-sight knowledge Identify required technologies: 1) to make possible 2) to make cheaper See what studies are currently under way (eg look through NASA Technology Inventory,…) Where does this fit in? Eg. This should also be a part of the VISNAV system Bring some awareness of these types of issues for our more challenging imaging missions to GSFC people. Better define the problem- the usual “scientist does not quite know how to describe the needs to engineer” difficulty…. Customer’s Goals of this Study

3. Requirements

4. Alignment Super Star Tracker 10 deg FOV State of the art pointing Arc sec Star Tracker (Science Instrument requirement) Lateral Knowledge Lateral control Along axis (Done on optics s/c) Laser (redundant) (issue laser life!) 10E20 photons/sec Laser Star Tracker Arc sec to inertial reference 10 deg looking at beacon Laser divergence 1 arc min 30 micro arc sec beacon Beacon telescope #2 5 arc sec FOV for telescope (PSF ~ 1.3 arc sec) 10 deg FOV State of the art pointing Arc sec Star Tracker (Science Instrument requirement) telescope #1 Lateral Knowledge + 7.5 micrometer Lateral Control + 10 cm Derived Tilt specs Knowledge 30 micro arc sec Control > 30 micro arc sec (derived from beacon & gyro/accelerometer) Roll 1 arc sec All fine control by detector s/c Knowledge + 5 cm Control + 5 m

5. 1) Similar to Hubble Space Telescope: Super Star Tracker Centroids on beacon FOV big enough to catch stars 2) Similar to Gravity Probe-B (GP-B): Telescope only centroids on beacon Gyro provides inertial reference frame 3) Similar to GP-B but use of accelerometers: University of MD like accelerometer (GEOID ESSP proposal using superconducting gravity gradiometer) Use fancy accelerometers with beacon May be linear or angular 4)Kilometric Optical Gyro Uses Sagnac Effect with light- precision ~/(Area/perimeter) For  = 630 nm, 4 km perimeter should be adequate Proposed for StarLight, but cost and technical issues 5) Space interferometry Mission - previously ruled out 6) Use of distance between S/C for very long focal length –ruled out Trade Studies

6. Super Star Tracker Centroids on beacon FOV big enough to catch stars Advantages Simple concept Aberration correction automatic Roll Possible use of superconducting accelerometer Chopper wheel to get small pixels fight 1/f noise Analog solution? Disadvantages FOV vs. resolution 15 magnitude stars => 1/4(arc min)2 Detector pixel size, capacity F-number = huge Integration time = huge Option 1: Hubble-Like

7. Telescope only centroids on beacon Gyro provides inertial reference frame Advantages Gyros exist!! 1/3 micro arc sec/day No need to find stars Just a beacon tracker telescope Cryo-cooler: TRL 5 by 2005 ($2-5M for cryo-cooler (flight model only), FM + EM $3 to $7 million, mass about 20kg Launches on Con-X ~ 2010 Gyro was to launch this year (Oct 2002) $10-100M for both cooler & gyro Disadvantages Must know aberration Delta-V to 3cm/sec (Landis checks) GP-B = expensive Cryogen or coolers/vibrations Option 2: Gravity Probe-B-Like

8. Deltas on GP-B Since 1/3 micro arc sec /day is not required, then we may be able to back off on this capability Cryo-coolers mean normal conductivity launching If negligible magnetic field @ L2, simplifies magnetic shielding design Requirements on magnets in s/c Neutralize cosmic-ray charging Respinning up gyro? (dynamic range) Cryo getters less important? Proof mass? Yes-maybe Squids will be better Venting vs. cooler mechanism Mass, power,size,cost,other req’ts (mag,jitter,thermal) Need to integrate over 10 sec you get 10E-13radians???? ConX, NGST Cooler specs: 150W BOL, 250W EOL, 10 yr lifetime, 20-30kg include electronics, heat syncs 1@100K, 1@room temp, produces 7.5mWatts 6K Selection in March 2002 Cryo cooler mating to Adiabatic Demagnetization Refrigerator (ADR) starts in 2005. Temperature 2 K or less. Estimate 30 watts. Option 2: Gravity Probe-B-Like (cont.)

9. Option 2: Gravity Probe-B-Like (cont. 2) FYI (Estimates from M. DiPirro): GP-B cost, size, weight TBD GP-B Reproduction without dewar and spacecraft Cost = $20 to $100 million Size: 0.5 meters diameter by 2 meters length Mass: about 100 kg LHe Dewar TBD values for comparison $25 to $50 Million size 2 meters diameter by 2 meters tall mass about 600 kg not recommended

10. University of MD like accelerometer (GEOID ESSP proposal using superconducting gravity gradiometer) Laboratory model measured 10E-15 m/s2 acceleration Use Super Accelerometers with beacon and beacon tracker Unable to project, but 1st look is the angular accelerometers will not work. Perhaps looking at angular displacements. Advantages No need to find stars No spin up Less sensitive to magnetics than GP-B option Squids will be better than GP-B Disadvantages Cryogen ? No flight design for accelerometers Delta-V to 3 cm/sec (aberration correction) charging Option 3: Super Accelerometers

11. University of MD like accelerometer (GEOID ESSP proposal using superconducting gravity gradiometer) Linear gravity gradiometer. Measure w2R (centripetal) D(w2)=10E-14 rad2/sec2/sqrt(Hz) Noise spectral density of Dw2 Dw= Dw2 /2w for w>>Dw Dw= sqrt(Dw2 )/sqrt2 for w~Dw We would operate with w~Dw Option 3a: Super Accelerometers

12. Kilometric Optic Gyro Resolution ~ lambda/(area/perimeter) Advantages Beacon star tracker only No need to find stars Disadvantages Extra s/c ? Understand “cost/technical” issues for StarLight de-selection Range control ? Option 4: KOG & Beacon

13. Koesters Prism Interferometer Interferometer Move detector in know pattern and AC detecting input signal. Then move s/c Fixed detector - look at fringes (DC). Then move s/c Centroiding Several (up to 5) defocus strips to reduce aberration and clarify point spread functions One centroid Quad cells Optically split beam PSF on 4 detectors Position Sensitive Diodes (for beacon) @ 633 nm (some of 3 and 4) Spatial heterodyne interferometric tracker (moiré pattern). Possible Techniques for Tracking

14. First Cut at Hardware Approach for Option 2 • 1. Use state-of-the-art star trackers for “coarse” pointing • - currently one arc second • - proposed Air Force milli arc second ST • 2. Use beacon on optics spacecraft and beacon detector on detector spacecraft to • maintain alignment or alignment knowledge of the two spacecraft to within 30 • micro arc seconds. Translate optics or detector spacecraft (decision based on • control design) based on beacon detector data . • 3. Use Gravity Probe-B type gyros on detector spacecraft to maintain knowledge • of inertial reference. If necessary, pitch or yaw spacecraft based on gyro data. • 4. Once the frequency of the disturbances are known for the beacon detector, • a decision could be made on whether or not to include state-of-the-art linear • accelerometers (recommended by Eric Stoneking) in each spacecraft. These • accelerometers would respond to any high frequency disturbances beyond the • capability of the beacon detector.

15. Coarse Acquisition Procedure • Use state-of-the-art star trackers (currently 8x8 degree FOV, accuracy of one arc second) to establish rough inertial reference of the optics and detector spacecraft. • Detector s/c star tracker sees the beacon; translate detector s/c to bring beacon into field of view of beacon tracker (15 arc seconds). This puts the beacon to within one arc second of the nominal position. • 3. Find science target on science instrument by translating detector spacecraft in search pattern. • 4. Use beacon tracker to control pitch and yaw of detector s/c so beacon is within 30 micro arc seconds of its most sensitive position. Reset gyros to zero at this point. • 5. Go into control logic sequence for science operations.

16. Science Mode Control Logic Sequence – Version Using Science Instrument Start Go to Start Go to Start no no X rays near Edge of Detector? Beacon Move? Gyro Move? Translate Detector Spacecraft yes yes no Go to Start yes Ranging done by time of flight laser on detector spacecraft used in separate range control logic sequence. X rays near Edge of Detector? Beacon Move? no no Go to Start yes yes Notes: 1. Beacon on optics spacecraft 2. Two gyros on detector spacecraft (for pitch and yaw) Drift about 1/3 micro arc sec per day. Several outputs from gyros, maybe to arc sec values with precision and accuracy of 30 micro arc seconds. 3. Beacon detector on detector spacecraft, 15 arc sec diameter field of view 4. State of the art star tracker on each spacecraft (8 x 8 degree field of view. 5. Field of view for science instrument x ray detector ( about 1 arc sec by 1 arc sec). Translate and Pitch/ Yaw Spacecraft Go to Start X rays near Edge of Detector? Translate and Pitch/ Yaw Spacecraft yes Go to Start no Go to Start

17. Go to Start Start Go to Start Go to Start no no • Delta • Theta B • Working FOV Of Beacon? Gyro Move? Beacon Move? Pitch and Yaw Detector Spacecraft yes no Translate Detector Spacecraft yes yes Delta Theta Beacon – Delta Theta Gyro = 0 ? • Theta B • Working FOV Of Beacon? Gyro Move? Translate detector Spacecraft yes yes no Go to Start no no Yes, means pure roll • Theta B • Working FOV Of Beacon? Go to Start no Go to Start • Delta • Theta Beacon • Working FOV Of Beacon? Ranging done by time of flight laser on detector spacecraft used in separate range control logic sequence. yes Pitch and Yaw detector Spacecraft yes Translate Detector Spacecraft no Go to Start Go to Start Go to Start

18. Science Mode Control Logic Sequence – Version Using Independent Tight Control Start Go to Start Ranging done by time of flight laser on detector spacecraft used in separate range control logic sequence. Gyro Move? Pitch/ Yaw detector Spacecraft yes no Start Go to Start Go to Start Beacon Move? Translate detector Spacecraft yes no Go to Start Note: Independent loops are coupled by dynamics

19. Super Star Tracker Beacon System

20. SIGNAL-TO-NOISE RATIO CALCULATION For the Laser Beacon we first calculate the diameter of the Laser Beam at the tracker, which is just the beam divergence in radians times the distance. We then calculate the area of the beam at the tracker. The ratio of this area and the telescope area is multiplied by the Laser Power to yield the received power. This received power is then propagated thru the system by multiplying by the next three factors, the telescope, the other optics, and the two beam splitters. The fourth factor to be multiplied is the quantum efficiency of the detector QE. The power is just converted to photons per second by the next two factors, Lam is the HeNe wavelength of 632.8 nm. With a millisecond integration time, the received photon number S is computed; and the signal to noise ratio SNR is computed as the square root of S in this photon noise limited case. The diffraction limited performance in object space, DL, is given by 2.44 l/( D*SNR), where D is the telescope diameter. For an interferometer limited by intensity noise, the phase error Df is given by the inverse of the product of the SNR and the square root of the number of data samples per fringe, SQRT(NS), ( Ref: Optical Shop Testing, Malacara). The optical path error (tilt), OPE, is given by (l/2p)Df, but it is also the angle error, IP, times D. The final result for IP is l/(2p* D*SQRT(NS)*SNR).

21. SNR CALCULATION

22. Thermal Meeting a pointing requirement of 30 micro arc sec requires extreme structural stability between the attitude sensor and the instrument. Mounting the attitude sensor and the instrument to the same platform would help accomplish this; in any case, the interfaces must be extremely rigid to prevent drift. In addition, temperatures must be tightly controlled to maintain dimensional stability, even with structural materials having a very low coefficient of thermal expansion (CTE). Allowable temperature difference was calculated as follows: 1. Assume a perfectly rigid structure. 2. Assume the best structural material currently available (M55J composite, with a CTE = 10-7 per oC) Since (sin 30 micro arc sec) is 1.5 x 10-10, this represents the distortion limit. The temperature change producing this error is (1.5 x 10-10) / (10-7) = 1.5mK Developing a lower CTE structural material should be a high research priority! Otherwise, temperature control must be to about 0.1mK, which has been done only in labs on very small sample volumes. Control to 1mK has been achieved on space instruments, but again in small volumes. This is another area requiring a technology upgrade.

23. Issues and Concerns • Laser reliability for long mission • Thermal stability of beacon detector telescope • Uniformity of laser intensity across diameter of beam • Maturity of cryo cooler • Maturity and adaptability of Gravity Probe-B gyros • Capability of PMTs • (count rate is a factor of 2 above current state-of-the-art)

24. 1) Hubble-like star tracker with superconducting accelerometer/aperture size trade. Inertial reference stars with beacon. 2) Gravity Probe-B like A) Unavailability of CDR package (wt, power, cost) B) Cryo-cooler option 1) Absorption - no moving parts 2) Isolated mechanical compressor 3) Rotary 5000 Hz (two of the three will be ready 2005) C) Modifications 1) S/C is non-rotating 2) Cold on ground 3) Better squids 4) Eliminate cryogen cooling 5) Spin up gas (Helium is dangerous to PMTs) 6) Magnetic shielding requirements @ L2 7) Lifetime (10 yrs) Open Issues

25. D) Strict dc mag field requirements for s/c components; no field lines thru GP-B gyro E) GP-B telescope modifications 1) Multiple tertiary mirrors for redundant detectors 2) Alternate design using interferometer (with prism) 3) PMT photon counting rate (requires improved technology) 3) Linear or angular superconducting accelerometer (requires improved technology) 1) 0.1 Hz = 1/f knee; so can integrate f @ 10 seconds 2) 7x10E-15 rad2/sec2=w2=linear acceleration=integration if white noise = ?? 3) Angular accelerometer=10E-12 rad/sec2=a=? , Value x time2? 4) Any additional input from U of MD Open Issues (cont.)

26. Back Up Charts

27. Detectors Note: Mass is 4 kg for 2 detectors