1 / 14

Fasteners Assignment Part C: 3/8-16 UNC-2A 1.5 FLAT HEAD

Fasteners Assignment Part C: 3/8-16 UNC-2A 1.5 FLAT HEAD. Check PDF packet page one for quick reference to page numbers… Start by drawing the following vertical rectangle .375x1.5. Offset top line down ½ D (0.1875) Draw a line from the blue circle intersection heading “@1<50”

kaethe
Download Presentation

Fasteners Assignment Part C: 3/8-16 UNC-2A 1.5 FLAT HEAD

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Fasteners AssignmentPart C: 3/8-16 UNC-2A 1.5 FLAT HEAD

  2. Check PDF packet page one for quick reference to page numbers… Start by drawing the following vertical rectangle .375x1.5

  3. Offset top line down ½ D (0.1875) • Draw a line from the blue circle intersection heading “@1<50” • Mirror angled line over to the left side of the fastener and fillet, trim, extend, / erase.

  4. Add slot for screw driver. Dimensions for height and width are 1/4D as noted in the book example.

  5. Check last page of PDF for dimensions of steel plates. • Top plate has a clearance hole for the fastener. • Bottom plate is tapped (threaded)- See page 1 of PDF for page number referencing threaded holes • Bottom plate has more threads cut than length of bolt, i.e. bolt can’t bottom out without fully tightening down. • Pilot hole (pre-drilled hole before tapping can occur) extends lower than threads and has 80 degree angle (same as the twist drill bit that cut the hole). Dimensions can be “eye balled.”

More Related