480 likes | 746 Views
Fiberglass Short Arm Cast Application and Removal. Application Supplies. Apply stockinette to upper and lower portion of arm as shown. Start wrapping cotton at wrist. Continue to hand. Apply two layers around hand and continue up arm. Tear cotton around thumb.
E N D
Apply stockinette to upper and lower portion of arm as shown
Fiberglass must be wet. Either fill a basin with water or use running water from sink.
Submerse in water or hold under running water for a few seconds
Repeat this step until desired thickness reached (two to three layers)
There should be two to three layers of cast material when finished
Use palms of hands to mold cast while it is drying (about 5 minutes)
Never use fingers as this can dent the cast and cause pressure sores
Turn arm over and make same cut along entire length of cast (inferior side)