1 / 12

Milling Circles and Arcs and Milling with Canned Cycles

Milling Circles and Arcs and Milling with Canned Cycles. 11/20/08. Review: Straight Lines. Initiated by MOVE command. Circles. Move the mill to the start of circle Put in arc mode with ARC.CW or ARC.CCW Specify center point Specify ARC. Arcs. Move the mill to the start of circle

kyleigh
Download Presentation

Milling Circles and Arcs and Milling with Canned Cycles

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Milling Circles and Arcs and Milling with Canned Cycles 11/20/08

  2. Review: Straight Lines • Initiated by MOVE command

  3. Circles • Move the mill to the start of circle • Put in arc mode with ARC.CW or ARC.CCW • Specify center point • Specify ARC

  4. Arcs • Move the mill to the start of circle • Put in arc mode with ARC.CW or ARC.CCW • Specify center point • Specify end point

  5. Arcs • Z matters

  6. Cylindrical Pockets • Move the mill to the start • Start pocket cycle with # sides and depth of each pass • Specify center point and final depth • Specify ARC

  7. Pockets • Move the mill to the start • Start pocket cycle with # sides and depth of each pass • Specify center point and final depth • Specify end point

  8. Cups • Move the mill to the start • Start cup cycle with # sides and depth of each pass • Specify center point and final depth • Specify ARC

  9. Cups • Move the mill to the start • Start cup cycle with # sides and depth of each pass • Specify center point and final depth • Specify ARC

  10. Partial Cups • Move the mill to the start • Start cup cycle with # sides and depth of each pass • Specify center point and final depth • Specify end point

  11. Partial Cups • Move the mill to the start • Start cup cycle with # sides and depth of each pass • Specify center point and final depth • Specify end point

  12. Drill • Drills holes • Begin with DRILL • Specify points • End with FINISH

More Related