Easily Replace Your Fluorescent Tubes with T8 LED Tube Light

1. Easily Replace Your Fluorescent Tubes with T8 LED Tube Light LED technology is a novel concept that has gained its popularity over the last couple of decades. LED lighting products are not only providing the customers with energy and money saving options, it also allows them to contribute their bit towards saving the environment. Among a wide range of lighting products available, T8 LED tube light is fast replacing the traditional fluorescent tube lights. Even though LED tube light and fluorescent tubes work in different ways; theoretically, LED tube lights are designed to replace the fluorescent tubes. Normally, electronic ballast is required in order to drive a fluorescent tube; whereas for LED tubes, it does not require such electronic ballast. LED tube lights vary greatly in size, quality, and material. Ultimate Advantage of LED Tube Lights The T8 LED tube light holds numerous advantages over the fluorescent tubes. They are:  LED tubes produce light in a wide variety of color temperatures.  It does not have any flickering issues.  The LED tubes are 30% more efficient than the fluorescent tubes.  The longer lifespan of the LED tubes does not get affected by switching the light on and off. How to Replace T8 LED Tube? Previously, fluorescent tubes were regarded as the cost-effective lighting solution. But with the coming up of LED lighting technology, LED tubes are gaining popularity. In order to replace the fluorescent tubes with T8 LED tube light, you will need to consult an electrician. On the other hand, you can try it on your own by following these steps.    You will need to turn off the circuit going to the fixture. Locate the ballast, cut wires from one end. Each socket on the fixture comes with two same color wires. Cut the wires, but make sure you have enough wires in order to connect with the entering AC power wire. You will have to use wire nuts in order to cover the exposed ends of the wires and thereby connect the connect line and neutral wires. Once the wiring gets completed, you can remove the ballast completely or leave it. You will then need to close the fixture and find out the AC input side of LED tube lamp.   

2.  While supplying power, make sure it is supplied to the AC input side or it might get a short circuit. Once the AC input side is attached to the AC power side, it is ready to use. Following these steps will help you to easily replace the fluorescent tubes with T8 LED tubes. Thereby, you can also save electricity bill by reducing energy consumption. Visit: https://initial-LED.com/product-category/tube-lights/