1 / 12

Installation Quick Guide AD400 Cylindrical

Installation Quick Guide AD400 Cylindrical . 6/01/13. Doc # 109579. Step 1: Install Door Position Switch. Step 2: Install Latch. Step 3: Install Clutch Assembly Remove cover plate and insert from outside Replace cover plate.

liseli
Download Presentation

Installation Quick Guide AD400 Cylindrical

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Installation Quick GuideAD400 Cylindrical 6/01/13 Doc # 109579

  2. Step 1: Install Door Position Switch Step 2: Install Latch

  3. Step 3: Install Clutch Assembly • Remove cover plate and insert from outside • Replace cover plate Before proceeding, verify the knob stop pin faces the edge of the door, IF NOT, re-handing is required

  4. Step 4: Align spindle assembly based upon key cylinder type Key in Lever Cylinder InterchangeableCore Cylinder Align horizontally as shown Turn clockwise until cam stops

  5. Step 5: Insert Key Cylinder and Lever • For locks with key in lever cylinders, place cylinder in lever • For locks with interchangeable cores, install the lever first, then insert cylinder • Insert key and turn 90 degrees to the right • Push in the knob stop pin and press lever on • Verify you can turn and remove key

  6. Step 6: Attach the four corner posts Step 7: Make sure triangles are aligned, insert spindle beveled side up IMPORTANT! Verify both triangles are aligned

  7. Step 8: Pull cable thru door as you place the lock body on the door  Step 9: Attached anti-rotation plate with two long beveled screws Step 10: Insert the two small screws

  8. Step 11: Attach inside lever to interior housing Step 12: Place spring on spindle and insert spindle beveled side up

  9. Step 12: Feed wires thru lock body as you place lock body in placeStep 13: Secure lock body in place with four screws (into the four posts on the exterior housing)  Step 14: Verify both the inside lever and the mechanical key retract the latch

  10. Step 15: Connect ribbon cable. Make sure the RED wire is on the leftStep 16: Trim and connect door position switch wires • Step 17: Carefully slide out the clear tab from under coin cell battery

  11. You’re Ready to Install the Reader Step 18: Verify the gasket is properly seated Step 19: Press reader in place Step 20: Secure reader with two long screws Do not over tighten

  12. Step 21: Apply the reflectorStep 22: Connect wireless communication moduleStep 23: Install back cover Step 24: Install batteries and cover plate

More Related