140 likes | 309 Views
009-i. CHAPTER. -Square Elbow with turning vanes. Aluminium tape. Aluminium tape. W+200mm. Square elbow. LN. W+350mm. W+350mm. Cover bottom. Cover top. 1. D raw the template of the cover bottom and cut toward “EXTERNAL”. Square elbow. 2.
E N D
009-i CHAPTER -Square Elbow with turning vanes
Aluminium tape Aluminium tape W+200mm Square elbow LN W+350mm W+350mm Cover bottom Cover top 1 • Draw the template of the cover bottom and cut toward “EXTERNAL”.
Square elbow 2 • Cut the walls and make the female before of to glue.
Square elbow Glue 3 • Glue all the sides cut at 45º
Aluminium tape Square elbow Exterior face 4 • Unite the four sides with aluminum tape for the exterior.
Square elbow Interior face 5 • Rotate the piece in position with the interior face up.
Square elbow 6 • Close the first side in position 90º vertical.
Square elbow 6 • Close the second side in position 90º vertical.
Square elbow 7 • Close the third side.
Square elbow 8 • Place the interior walls.
Pressing Silicon inside Aluminium tape Square elbow 9 • To press, to tape, to clip and to make the male.
Square elbow 10 • Insert the kit “Turning Vanes”.
Nut M6 Reinforcement disk Tierod M6 Reinforcement disk Nut M6 Square elbow 10 • Insert the kit of “Turning Vanes”.