1 / 46

Respiratory Protection in Primary Care

Respiratory Protection in Primary Care. Deborah Gold, MPH, CIH dgold@hq.dir.ca.gov January, 2010. California Aerosol Transmissible Disease Standard. Became effective August 5, 2009 Applies in most health care environments, including primary care

Download Presentation

Respiratory Protection in Primary Care

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Respiratory Protection in Primary Care Deborah Gold, MPH, CIH dgold@hq.dir.ca.gov January, 2010

  2. California Aerosol Transmissible Disease Standard • Became effective August 5, 2009 • Applies in most health care environments, including primary care • Title 8, California Code of Regulations, Section 5199 http://www.dir.ca.gov/Title8/5199.html

  3. What is an Aerosol Transmissible Disease? • A disease • That is transmitted by aerosols (A gaseous suspension of fine solid or liquid particles)

  4. Disease Agents Act at Different Places in the Respiratory Tract

  5. Work settings covered by the ATD Standard • Applies in health care, such as: • Hospitals • Long Term Health Care Facilities • Primary Care • Emergency Medical • Applies in other high risk environments • Corrections • Homeless shelters • Drug treatment programs • First receiver • Laboratories

  6. Droplet vs. Airborne • CDC divides diseases between those believed spread by: • large droplets that hit mucous membranes • small particles that are inhaled • The ATD standard adopts this system although there is substantial evidence that many “droplet” diseases have an airborne route of transmission • Default for novel diseases is airborne • At this time, respirators are required for H1N1

  7. Airborne spore release (e.g. anthrax) until decon Chickenpox (Varicella) Highly pathogenic avian influenza Herpes zoster (varicella-zoster, disseminated disease, per CDC) Measles (rubeola) Monkeypox SARS (Severe Acute Respiratory Syndrome) Smallpox Tuberculosis Cal/OSHA added: Novel or Unknown pathogen Any disease for which CDPH recommends AII Airborne Infectious Diseases

  8. Diptheria Influenza Meningococcal disease Mumps Mycoplasma pneumonia Pertussis Plague (pneumonic) Rubella SARS Viral hemorrhagic fevers Diseases for which CDPH recommends droplet precautions Some Droplet diseases

  9. Is My Facility a “Referring Employer?” • Screen persons for airborne infectious diseases (AirID). • Refer any person identified as a case or suspected case of and Airborne Infectious Disease. • Not intend to provide further medical services to AirIDcases and suspected cases beyond first aid, initial treatment or screening and referral (no high hazard procedures on ATD cases) • Exception for novel pathogens – may maintain in facility if not feasible to provide AII • Not provide transport, housing, or airborne infection isolation to any person identified as an AirID case or suspected case, • Exceptions: may provide non-medical transport in the course of a referral • May provide housing and isolation if AII not feasible for novel pathogens

  10. Most Primary Care Operations are probably “referring employers.” It is up to your facility to determine what services you can provide safely to patients and adopt appropriate precautions. Higher levels of care, may place you under the full scope of the standard.

  11. Referring Employers(subsection c) • Source control, including early identification, cover cough, separation • Screening procedures for airborne infectious diseases (AirIDs) • Medical • Non-medical (App. F) • Have a system for timely referral (transfer) including getting information back • Train employees • Respirators for: • AirID cases not referred • AirID cases during initial treatment who are not using source control, unless respirator use not feasible

  12. Referring Employers(subsection c) • Have a system for exposure incidents, including precautionary removal, and TB surveillance • Provide additional CDC recommended vaccines to HCWs (effective 9/1/10) • Provide seasonal flu vaccine to all employees with occupational exposure • Record keeping

  13. Protecting Health Care Workers in Non-Hospital Environments • Early recognition of potential cases • Respiratory Hygiene • Separation of patients, limiting contact • Referral of patients needing airborne infection isolation • Respiratory protection when appropriate • Hand hygiene, cleaning and disinfection of surfaces • Vaccination and other medical follow-up • Training

  14. Why Do We Need Respirators • When people breathe, talk, sing, cough, or sneeze moist warm droplets are emitted • The droplets are of various sizes • The droplets quickly lose water and become smaller • Droplets of up to 100 microns may remain airborne long enough to be inhaled • Influenza receptors are located throughout the respiratory tract • Respirators, but not surgical masks, seal to the face and force air to pass through filtering media

  15. When are Clinics required to use respirators • While exposed to a patient who is a suspected or confirmed case of H1N1, TB or other AirID if patient not using source control measures, e.g. • if examining upper respiratory tract • if patient has bad cough and can’t use mask • If high hazard procedures are performed on AirID patients (not referring employer) • As of September 1, 2010 higher levels of protection are required for high hazard procedures

  16. Respirators and Surgical Masks

  17. Respirators vs. Surgical Masks Protection provided by device without fit-testing *protection is outside concentration/inside concentration Robert B. Lawrence, Matthew G. Duling, Catherine A. Calvert and Christopher C. Coffey , 'Comparison of Performance of Three Different Types of Respiratory Protection Devices', JOEH 3:9, 465 - 474

  18. Multiple Surgical Masks Derrick JL, Gomersall CD. Protecting healthcare staff from severe acute respiratory syndrome:filtration capacity of multiple surgical masks. In Journal of Hospital Infection (2005)59, 365-368.

  19. The Institute of Medicine Report • Health care workers caring for H1N1 patients should use fit-tested N95 respirators or more effective respirators. • September 2009

  20. Respirator Basics • Respirator use in health care is regulated by Section 5199 and Section 5144 (federal 29 CFR 1910.134) • Requirements • Reduction of hazard with engineering and administrative controls • Written program and designated administrator • Hazard assessment • Selection of appropriate, NIOSH approved respirators

  21. Respirator Basics (cont) • Medical Evaluation • Fit-testing (initial and periodic) • User procedures including seal check, cartridge change, and procedures for IDLH • Procedures for storage, maintenance, cleaning and disinfection • Training • Record Keeping • Program evaluation including employee involvement

  22. Respirator Selection

  23. Air Purifying Respirators • Air purifying respirators remove contaminants from the air being inhaled by the user • Conventional APR has negative pressure in the facepiece, and is tight-fitting (generally) • Powered APR may have positive pressure, and may be a hood, helmet, or tight-fitting facepiece • N95 and other filters do not protect against gases and vapors • APRs and PAPRs do not have an air source, and therefore can not be used in oxygen deficient atmospheres or if immediately dangerous to life or health (IDLH)

  24. N95 Respirators These respirators only reduce particulates, not gases or vapors

  25. Elastomeric Facepieces Cartridges are available for particulates only, and for specific levels of gases or vapors.

  26. Powered Air-PurifyingRespirators(PAPR)

  27. Atmosphere Supplying Respirators • Provide their own source of air (compressor, air tank, or portable air tank) • Can be positive or (rarely) negative pressure • Can be tight-fitting facepiece, or hood or helmet • Generally do not filter air being exhaled

  28. SCBA

  29. Filtering Facepiece Respirators • Nose bridge sealing surface • Adjustable or fixed • Chin sealing surface • Straps and attachment • Also fluid resistant (“surgical N95”) • Filter – N, R, or P, 95, 99 or 100 • Exhalation Valve • Fold Flat • Latex free • Fit

  30. Respirator Designs Vary

  31. Respirator Designs Vary

  32. Medical Issues with Respirator Use • Increased resistance to air flow • Increased dead space volume • Increased CO2 • Heat effects, particularly if used in conjunction with other PPE • Physical work, ergonomics – particularly with SCBA • Claustrophobia • Limits to communications

  33. Confidential Medical Evaluations • Medical Evaluation must have the content of the questionnaire in Section 5144, Appendix C • ATD standard permits the use of a shorter questionnaire in Section 5199, Appendix B • Questionnaire is available on many websites • Must be evaluated by a PLHCP who can order additional tests • A “yes” answer to any specified question requires “further evaluation” • No interval is specified for re-evaluation – the PLHCP and employer should specify

  34. Fit-testing • The purpose of fit-testing is to ensure that a selected respirator will provide the required protection factor. • Allowed fit-test methods are in Appendix A to Section 5144. • Qualitative fit-tests use a challenge agent: • bitrex, saccharine, irritant smoke, or isoamyl acetate. • Quantitative fit-tests measure leakage: • Generated aerosol, ambient aerosol, controlled negative pressure.

  35. Qualitative Fit Test

  36. Quantitative Fit Test

  37. Do N95’s need to be fit-tested? 1996 NIOSH laboratory study of 25 subjects with 21 models of N95s found • Without fit-testing, the average protection factor for all subjects using a respirator was 3. • By selecting out bad fits, using a fit-test, the average protection factor was 25 • Only four models passed a fit-test for the majority of participants. Three did not pass the fit-test for any participant. Laboratory Performance Evaluation of N95 Filtering Facepiece Respirators, 1996. MMWR Morb Mortal Wkly Rep. 1998 Dec 11;47(48):1045-9.

  38. Effect of Fit-testing N95 Source: Robert B. Lawrence, Matthew G. Duling, Catherine A. Calvert and Christopher C. Coffey , 'Comparison of Performance of Three Different Types of Respiratory Protection Devices', JOEH 3:9, 465 - 474

  39. Additional Fit Tests • To be provided if employee requests additional fit test • If employee has weight gain or loss, facial changes (such as surgery or dental work) that may effect fit • At least annually • Exception in Section 5199 for non-high hazard, permits biennial until 1/1/2014 • Must provide Appendix G info in alternate years

  40. N95 User Procedures • User seal check difficult to perform on filtering facepiece respirators • Can not be used in atmospheres “immediately dangerous to life or health” • Will not protect against gases or vapors, only particles (including mists) • Change respirator (filtering facepiece) or cartridge when breathing becomes more difficult or if dirty, wet, etc.

  41. What’s Wrong with this Picture? • Respirators do not work if they do not seal to the face. • Facial hair must not interfere with the seal. • Straps must be directly seated on the head, in this case above and below the ear

  42. N95 Maintenance, Storage, Inspection • Every respirator should be inspected prior to putting it on, to make sure the straps are okay, it is not torn, deformed, dirty, etc. • Generally filtering facepiece respirators used against infectious particles should be disposed each time they are removed • If shortage prevents disposal, employer should have storage and re-donning procedures, including procedures for handling respirator to prevent contamination • No respirator should be put on if it is torn, wet, dirty, or unable to form a facepiece seal

  43. Initial and Annual Training Required training elements • Why the respirator is necessary and how improper fit, usage, or maintenance can compromise respirator protective effect ;  • Limitations and capabilities of the respirator • Emergency use and what to do it respirator malfunctions •  How to inspect, put on and remove, use, and check the seals of the respirator;  • maintenance and storage of the respirator;  • Medical signs and symptoms that may limit or prevent the effective use of respirators; and  • General requirements of regulation 

  44. Program Review • At least annual • Consult with affected employees Record Keeping • Medical evaluations per 3204 • Most recent fit-test • Appendix G to 5199 • Current respirator program made available

  45. Help with Respirators • Cal/OSHA consultation:1(800) 963-9424 • California Association of Health Facilities, model program http://www.cahfdownload.com/cahf/dpp/CAHF_ModelRespiratoryProtectionProgram.pdf • Occupational Health Branch train-the-trainer programs -- TBA • Respirator manufacturers and distributors • Workers’ comp insurance carriers

  46. Find Cal/OSHA on the Web • Cal/OSHA ATD standard: • http://www.dir.ca.gov/Title8/5199.html • Advisory committee webpage: • http://www.dir.ca.gov/dosh/DoshReg/advisory_committee.html • Respiratory protection regulation • http://www.dir.ca.gov/Title8/5144.html • Respiratory Protection in the Workplace • http://www.dir.ca.gov/dosh/dosh_publications/respiratory.pdf

More Related