1 / 45

Inosilicates (chain)

Inosilicates (chain). Common Fe/Mg – bearing silicates Two common groups Pyroxenes: single chains Amphiboles: double chains Pyroxenes are common in MORB Amphiboles more common on continents because of weathering. Pyroxene group. General formula: XYZ 2 O 6 Z/O ratio = 1/3

mcinnis
Download Presentation

Inosilicates (chain)

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Inosilicates (chain) • Common Fe/Mg – bearing silicates • Two common groups • Pyroxenes: single chains • Amphiboles: double chains • Pyroxenes are common in MORB • Amphiboles more common on continents because of weathering

  2. Pyroxene group • General formula: XYZ2O6 • Z/O ratio = 1/3 • Z cations usually Si, occasionally Al • Single chain extend along c axis • Chains are stacked along a axis, alternating: • Base faces base • Apex faces apex

  3. View down c axis View down a axis Fig. 14-1 Two distinct sites, depending on location relative to chains M1 and M2 Base facing base Apex facing Apex

  4. X cations in M2 sites • Between bases of tetrahedrons • Distorted 6- and 8- fold coordination • Depends on stacking and the size of the cations • Y cations in M1 sites • 6-fold coordination between apical oxygen

  5. “I-beams” • Consist of two chains connected by Y cations • Located in M1 sites • Closeness of apical oxygen and 6-fold coordination make bonds strong Apex pointed at apex I-beam

  6. I-beams held together by X cations in M2 site • Coordination number depends on how chains line up • 6-fold coordination gives orthorhombic symmetry - OPX • 8-fold coordination gives monoclinic symmetry - CPX

  7. Crystallographic and optical axes align C crystallographic axis at 32 to 42º angle to the Z optical axis Pigeonite – CPX - Monoclinic OPX - Orthorhombic

  8. Crystal shapes • Blocky prisms, nearly square • Elongate along c axis • Cleavage controlled by I-beams • Cleavage typically between 87º and 93º • Only when viewed down the c axis • Mineral grain must be cut parallel to (001)

  9. Fig. 14-1 I beams – tightly bonded Weak zones between faces of I beams Weak planes between “I beams” = cleavage Cleavage angles are 87º and 93º

  10. Classification • Based on two linked things • Which cations occurs in M2 sites (facing bases of tetrahedron) • Cation determines symmetry • Most plot on ternary diagram with apices: • Wollastonite, Wo • Enstatite, En • Ferrosilite, Fe

  11. Three major groups • Orthopyroxenes (opx) – orthorhombic • Low-Ca clinopyroxenes (cpx) – monoclinic • Ca-rich clinopyroxenes (cpx) – monoclinic • The amount of Ca in the mineral controls the extinction angle

  12. Orthopyroxenes: Fe and Mg, but little Ca • Both M1 and M2 are octahedral • Larger Fe ion more concentrated in M2 site (larger)

  13. Low-Ca clinopyroxene: more Ca, but no solid solution with Hi-Ca clinopyroxene • Mineral species is Pigeonite • Ca restricted to M2 sites, these still mostly Fe and Mg • M1 sites all Mg and Fe

  14. Ca- clinopyroxene • Diopside Mg(+Ca) to Hedenbergite Fe (+Ca) • M2 site contains mostly Ca • M1 site contains mostly Fe and Mg • Most common specie is augite • Al substitutes in M1 site, and for Si in tetrahedral site • Na, Fe or Mg substitutes for Ca in M2 site

  15. Other common pyroxenes • Jadeite NaAlSi2O6 • Spodumene LiAlSi2O6

  16. Possible ranges of solid solutions Fig. 14-2 “Augite” Clinopyroxene Orthopyroxenes Na – bearing pyroxenes

  17. Identification in hand-sample difficult • Mostly based on occurrence • Also color can be indicative • Optical properties distinguish clino- from ortho-pyroxenes • If composition is important, need chemical analysis

  18. Geology of pyroxenes • Igneous • Common igneous pyroxenes: augite, pigeonite, and opx • Augite most common • Usually in mafic and intermediate volcanics • Both intrusive and extrusive • Zoning common: magma becomes enriched in Fe because of partition of Mg into crystals • Requires 3 component phase diagram • Exsolution common – cooling allows rearrangement of Ca

  19. Exsolution mechanisms • Augite original crystallization • Ca substitution in M2 sites restricted • As cools, Ca reorganizes • Generally find exsolution lamellae of pigeonite (low Ca cpx) within host augite parallel to (001) or opx parallel to (100) Augite Matrix

  20. Opx crystallize at high T with excess Ca – up to 10% • Slow cooling allows Ca expelled to form exsolution of augite (hi-Ca cpx) • Single lamellae of augite parallel to (100) • Bushveld variety – S. Africa type location Opx Matrix

  21. Pigeonite grows in mafic magma • Up to 10% Ca in M2 site • Cooling causes Ca to expel and form augite (hi-Ca cpx) lamellae • Single lamellae parallel to (001) Pigeonite Matrix

  22. If slow enough pigeonite converts to opx • Pigeonite only preserved where cooling fast (volcanic) • Slow cooling creates second set augite (hi-Ca cpx) parallel to (100) • “Stillwater type” Opx Matrix

  23. Metamorphic • Carbonate rocks, typically diopside because of Ca and Mg from calcite and dolomite • Amphibolite common association (water) • Na and Ca clinopyroxenes • Typically restricted to high T and low P conditions • Found at subduction zones (blue schist facies)

  24. Opx also in granulite facies rocks • Hot enough to remove water • Derived from amphiboles

  25. Sedimentary • Not stable (anhydrous) • Converts to clay minerals

  26. Amphibole Group • Structure, composition, and classification similar to pyroxenes • Primary difference is they are double chains • Z/O ratio is 4/11

  27. Structure • Chains extend parallel to c axis • Stacked in alternating fashion like pyroxenes • Points face points and bases face bases

  28. Shared O Fig. 14-12 • Chains are linked by sheets of octahedral sites • Three unique sites: M1, M2, and M3 • Depend on location relative to Si tetrahedron Not shared O OH

  29. TOT layers • Two T layers (tetrahedral layers with Z ions) • Intervening O layer (octahedron) with M1, M2, and M3 sites • Form “I-beams” similar to pyroxenes

  30. Geometry produces five different structure sites • M1, M2, and M3 between points of chains • M4 and A sites between bases of chains

  31. Bonds at M4 and A sites weaker than bonds within “I-beams” • Cleavage forms along the weak bonds • “I-beams” wider than pyroxenes • Cleavage angles around 56º and 124º Weak planes between “I beams” = cleavage

  32. CompositionW0-1X2Y5Z8O22(OH)2 • Each cation fits a particular site • W cation • Occurs in A site • Has ~10 fold coordination • Generally large, usually Na+

  33. W0-1X2Y5Z8O22(OH)2 • X cations • Located in M4 sites • Analogous to M2 sites in pyroxenes • Have 6 or 8 fold coordination depending on arrangement of chains • If 8-fold, X usually Ca • If 6-fold, X usually Fe or Mg

  34. W0-1X2Y5Z8O22(OH)2 • Y cations • Located in M1, M2, and M3 sites; Octahedral cations in TOT strips • Usually Mg, Fe2+, Fe3+, Al • Z cations • Usually Si and Al

  35. Composition • Most common amphiboles shown on ternary diagram • Wide variety of substitution, simple and coupled • Divided into ortho and clino amphiboles • Depends on X cations in M4 site (largely amount of Ca), distorts structure • Reduces symmetry from orthorhombic to monoclinic

  36. W0-1X2Y5Z8O22(OH)2 Fig. 14-13 Tremolite Ferroactinolite ~30% Ca exactly 2/7 of sites available for Ca Grunerite Monoclinic Anthophylite Orthorhomic

  37. Pyroxenes and Amphiboles

  38. Identification • Hand sample and thin section difficult • Best method is association • Ca and Na amphiboles commonly dark green to black, pleochroic: usually Hornblende • White or pale green amphiboles usually called tremolite

  39. Geology of amphiboles • Several important aspects • Hydrous – water part of their structure • Not stable in anhydrous environments • Dehydrate at high temperature • High Z/O ratio (4/11) mean they should occur in Si-rich rocks

  40. Generalization • Not common in mafic and ultramafic rocks • Crystallize late in magmatic history; melt rich in Si and H2O • Overgrowths of amphibole on pyroxenes common • Common in felsic to intermediate rocks • Fe and Mg minerals either amphibole or biotite • Depends on abundance of K (biotite) and Ca/Na (amphiboles) • Generally amphibole tends toward intermediate rocks; biotite toward felsic

  41. Amphiboles common in regional metamorphism of intermediate to mafic rocks • Usually water rich from breakdown of clay and micas • Metamorphic rock with abundant amphiboles called amphibolitefacies • At high T, amphiboles break down to pyroxenes Note – these generalities are likely to be wrong

  42. Pyroxenoid Group • Similar to pyroxenes • Single chains • Z/O ratio 1/3 • Differ in repeat distance along c axis • Pyroxene – 2 tetrahedron repeat (5.2 Å) • Pyroxenoid – 3 or more repeat (more than 7.3 Å) • Difference is the pyroxenes are straight pyroxenoids are kinked • Cased by larger linking cations

  43. Pyroxenes Rhodenite - Mn Wollastonite - Ca

  44. Only a few minerals • Most common Wollastonite – Ca • Others are Rhodonite – Mn • Pectolite – Ca and Na

  45. Wollastonite • Composition: Ca with some Mn and Fe substitution • Common in altered carbonate rocks, particularly with reaction with qtz • Useful industrial mineral, replacing asbestose, also used in paints and plastics

More Related