140 likes | 283 Views
How to Program with JTAG. ECE 353 – Computer Systems lab I Mike O’Malley Tom Stack September 20 th 2005. Quartus II – Tools -> Programmer. Click on “Hardware Setup…”. Click “Add Hardware” For the parallel port version select ByteBlasterMV The printer port (LPT1) For the USB version
E N D
How to Program with JTAG ECE 353 – Computer Systems lab I Mike O’Malley Tom Stack September 20th 2005
Click “Add Hardware” For the parallel port version select ByteBlasterMV The printer port (LPT1) For the USB version TBD Click “Ok” Click “Close” Hardware Setup
Schematic for JTAG programming http://www.altera.com/literature/an/an095.pdf http://www.altera.com/literature/ds/m7000.pdf
WARNING! DISCONNECT 4Mhz CLOCK BEFORE ATTACHING TO PROGRAMMER
Quickly Check for burning chip Unplug Power Check connections Is the clock unplugged? Ask the TA for assistance Bad!
Navigate to your project folder Select the .pof file created from compilation Click “Open” Select your .pof file
All Green is good Unplug power Unplug programmer Connect clock Connect Power Red is bad Check connections Ask TA for help Programming Complete