1 / 11

Selective Catalytic Reduction (SCR) by NH 3 in a Fixed-Bed Reactor

Selective Catalytic Reduction (SCR) by NH 3 in a Fixed-Bed Reactor. HEE JE SEONG The Department of Energy and Geo-Environmental Engineering The Pennsylvania State University. Introduction. NOx emissions are a major pollutant from engines, incinerators and power plants

nishi
Download Presentation

Selective Catalytic Reduction (SCR) by NH 3 in a Fixed-Bed Reactor

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Selective Catalytic Reduction (SCR) by NH3 in a Fixed-Bed Reactor HEE JE SEONG The Department of Energy and Geo-Environmental Engineering The Pennsylvania State University

  2. Introduction • NOx emissions are a major pollutant from engines, incinerators and power plants - unavoidable at conditions where air is involved at high combusting temperature • Selective catalytic reduction with NH3 has been successfully used to remove NOx 4NO + 4NH3+ O2  4N2 + 6H2O • Kinetic parameters depend much on a catalyst - V2O5-WO3/TiO2, CuHM and etc

  3. Governing Equations • Mass equation - Convection and diffusion where R : -rNO, -rNH3 • Momentum equation - Navier-Stokes equation (Brinkman eqn. involved) • Energy equation - Assumed as an isothermal state due to a small amount of heat evolved

  4. Boundary Conditions • Inlet - Velocity : 1, 2, 4m/s - CNO = 8.16x10-3mol/m3 CNH3 = 8.16x10-3mol/m3 CNH3 = 6.94x10-3mol/m3 CNH3 = 9.38x10-3mol/m3 - Pin : 1.01325x105Pa • Outlet - P : Pin – ΔP (according to Ergun eqn.) Inlet 0.1(m) Wall/ Insulation Wall/ Insulation 0.076(m) Outlet

  5. Formulation • Mass conservation - Convection and diffusion - Chemical reaction ENO : Enthalpy of NO reduction ENH3 : Enthalpy of NH3 oxidation HNH3 : Heat of NH3 adsorption kNO : Reaction rate constant of NO reduction kNH3 : Reaction rate constant of NH3 oxidation KNH3 : Adsorption equilibrium constant for NH3

  6. Formulation • Air is assumed as the fluid flowing through the reactor - small amounts of NO and NH3 - ρ and η are temperature-dependent - pressure drop is calculated using Ergun eqn. - Permeability is calculated using Darcy’s law

  7. Solution • Much portion of reactants is converted in the inlet of the reactor • NH3 slip should be considered when NH3 is injected

  8. Validation SV = 100,000 h-1 SV = 200,000 h-1 • Detailed information in Chae et al’s model is missing • This COMSOL model simulates similar trends of results to • those of Chae et al.’s model for both conditions

  9. Parametric Study

  10. Parametric Study • Conversion of NO is higher at a dry condition than at a wet condition • due to the competition between H2O and NH3 • This COMSOL model also reflects a general phenomenon of SCR • when water is involved in the reaction

  11. Conclusion • SCR model using COMSOL well describes a general trend of NO removal performance - Valid result compared to the reference - Water effect is predictable • The model also indicates that NH3/NO should be controlled considering NH3 slip and performance at operating temperatures

More Related