3.62k likes | 10.25k Views
VISCOSITY. Viscosity. is the quantity that describes a fluid's resistance to flow. It exists in both liquids and gases and is essentially a friction force between different layers of fluid as they move past one another .
E N D
Viscosity • is the quantity that describes a fluid's resistance to flow. • It exists in both liquids and gases and is essentially a friction force between different layers of fluid as they move past one another. • In liquids the viscosity is due to the cohesive forces between the molecules. • in gases the viscosity is due to collisions between the molecules.
Viscosity cont’d…. • represented by the symbol η "eta“ • is the ratio of the shearing stress (ƒ/A) to the strain rate (v/l). • SI unit of viscosity is the Pascal second [Pa s]. • A common unit is the poise (P) where 1 Pa.s = 10 P
Types of viscosity • Dynamic or Simple viscosity • Kinematic Viscosity
Kinematic Viscosity • a measure of the resistive flow of a fluid under the influence of gravity. • represented by the symbol ν "nu“ • ratio of the viscosity of a fluid to its density. • Can be measured using the Capillary Viscometer. • SI unit of kinematic viscosity is the [m2/s]. • Common unit used is the stroke (St) = [cm2/s] v=ŋ/ρ
Factors affecting Viscosity 1. Viscosity is very temperature dependent. • Viscosity of a liquid decreases with increasing temperature. Ex. It is easier to pour skin lotion during summer than cold season. Different oils are used in hot and cold countries. • Viscosity of a gas increases with increasing temperature.
Factors affecting Viscosity 2. Viscosity is normally independent of pressure, but liquids under extreme pressure often experience an increase in viscosity
Viscosity cont’d…. • Viscous fluids tend to cling to a solid surface. • Syrup and honey are more viscous than water. • Grease is more viscous than engine oils. • Liquids are more viscous than gases. • Lava is an example of a very viscous material.
Equation of Continuity • When fluids move through a full pipe, the volume of fluid that enters the pipe must equal the volume of fluid that leaves the pipe, even if the diameter of the pipe changes. • This equation says that as the cross-section of the pipe gets smaller, the velocity of the fluid increases, and as the cross-section gets larger, the fluid velocity decreases.