1 / 9

Dimensioning Standards Part 2

Dimensioning Standards Part 2. Dimensioning Angles. Angular method One location distance and the angle. Coordinate Method Two location distances of the angle. Arcs and Curved Features. Dimensioned in views that show the arc Leader identifies radius May include center mark. Capital

oni
Download Presentation

Dimensioning Standards Part 2

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Dimensioning Standards Part 2

  2. Dimensioning Angles • Angular method • One location distance and the angle. Coordinate Method Two location distances of the angle.

  3. Arcs and Curved Features • Dimensioned in views that show the arc • Leader identifies radius • May include center mark Capital “R” for radius Small arcs do not need center marks. Arrow can be outside. Large Arcs use Center marks

  4. Circles • Have a center mark • Leader identifies diameter • Holes have “Hole Notes”  = diameter Hole Note: This hole has .5” diameter and is 1.00” deep

  5. Reading Hole Notes Hole Depth is .75” Diameter is 0.25” Counterbore Diameter of Counterbore is 0.38” Depth of Counterbore is 0.25” OR Hole extends through block or material Diameter is 0.38”

  6. Unified National Thread Note Threads per Inch (TPI) Major Diameter C = coarse F = fine

  7. Reading a ISO Thread Notes Prior to THRU, LH for left hand thread. THRU or a depth may be specified Pitch of the threads Grade of thread tolerance from fine to coarse (3,4,5,6,7,8 or 9) G = tight allowance H = no allowance. M for Metric Nominal Diameter In Millimeters

  8. Standards Institutions • ANSI - American National Standards Institute • This institute creates the engineering standards for North America. • ISO - International Organization for Standardization • This is a world wide organization that creates engineering standards with approximately 100 participating countries.

More Related