1 / 15

An Efficient Duty Cycle Based Communication Scheme for Wireless Sensor Network

Proposed protocol aims to improve energy efficiency and throughput in wireless sensor networks by optimizing communication under varying traffic loads.

raphaelr
Download Presentation

An Efficient Duty Cycle Based Communication Scheme for Wireless Sensor Network

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. The 32nd KIPS Fall Conference 2009 An Efficient Duty Cycle Based Communication Scheme for Wireless Sensor Network Md. Obaidur Rahman1, Muhammad Mostafa Monowar1, Cho Jin Woong2, Lee Jang Yeon2 and Choong Seon Hong1 1Kyung Hee University and 2Korea Electronics Technology Institute, South Korea.

  2. Introduction • Energy is the most critical issue for wireless sensor network (WSN), due to the limited battery life time. • Especially, for a monitoring application the operation of a sensor network is quite challenging • Most of the time very low traffic • Possibility of high traffic burst on the detection of any event • To fulfill the demand of such WSN, network life time should be increased in low traffic, while increase the throughput in heavy traffic as well. • Considering this motivation, a receiver-initiated communication protocol is proposed in this paper.

  3. Problem Statement • Problems in synchronous S-MAC and asynchronous AS-MAC: • Sleep schedule caused packet delay • Single packet reception at each wake-up Tx Receiver Data Data Data Rx Tx Data Sender 1 Rx Tx Data Sender 2 Rx Tx Data Sender 3 Rx

  4. Goals • Our proposed work has the following goals: • Energy efficient communication bypassing the most common sources of energy wastes, i.e., idle listening, overhearing etc. • Optimize delay in both low and high traffic load. • Better throughput assurance under heavy load.

  5. Preliminaries • Operational Cycle • This is the time period for the wake-up interval of the nodes in the network: • Duty Cycle • It is the ratio between node's active time to its entire cycle time. • Active time includes all the actions and activities of a node (i.e., channel access, transmission and reception of data, etc.). • Two phase • Fair Access Period (FAP) • Prioritized Access Period (PAP)

  6. Proposed Communication Protocol • Fair Access Period (FAP) • Receiver End: • Receiver-initiated channel access by sending a beacon packet • At this phase, a receiver wakes-up and receives only a single packet from each of the upstream senders and acknowledge those packets • After receiving the final packet at FAP, it announces the channel access schedule in the prioritized access phase • Sender End: • Receives the beacon and after contention resolution, send the data • Senders those looses the contention, waits for the ACK for previous data and contend again after receiving the ACK • Piggyback the information of additional data packet in the packet header and request for prioritized channel access

  7. Proposed Communication Protocol • Prioritized Access Period • Receiver End • Receiver assigns priority according to the current traffic at the senders and announces the prioritized channel access schedule • Receive back-to-back packet from the same sender and send a block ACK • Sender End • Follows the schedule assigned by the receiver • Send back-to-back packet

  8. Proposed Communication Protocol • Fair Access Period (FAP) and Prioritized Access Period

  9. Experimental Validation • Simulation in Ns-2 is performed. • Uniform random distribution of 100 nodes in 100 x 100 m2 area. • Wake-up interval is considered as 1 second. • Traffic load is varied between 0.1 to 4.0 pkts/s. • Simulation time is 100 seconds. • Compared only the energy, delay and throughput performance are measured from the simulation results.

  10. Experimental Validation • Energy Usage

  11. Experimental Validation • Delay

  12. Experimental Validation • Throughput

  13. Conclusion • This paper proposes a different idea in terms of multiple packet reception in each wake-up • Hence, reduce the packet delay • In event detection, increases the throughput • It is also energy efficient when the network traffic is low. • Future work • Extend the work for an asynchronous scheduled MAC with multiple wake-up provisions in each operational cycle

  14. References • W. Ye, J. Heidemann, and D. Estrin, “Medium access control with coordinated adaptive sleeping for wireless sensor networks," IEEE/ACM Trans. Netw., vol. 12, no. 3, pp. 493-506, 2004. • J. Polastre, J. Hill, and D. Culler, “Versatile low power media access for wireless sensor networks," in SenSys '04: Proceedings of the 2nd international conference on Embedded networked sensor systems. New York, NY, USA: ACM, 2004, pp. 95-107. • M. Buettner, G. V. Yee, E. Anderson, and R. Han, “X-mac: a short preamble mac protocol for duty-cycled wireless sensor networks," in SenSys '06: Proceedings of the 4th international conference on Embedded networked sensor systems. New York, NY, USA: ACM, 2006, pp. 307{320. • Y. Sun, O. Gurewitz, and D. B. Johnson, “Ri-mac: a receiver-initiated asynchronous duty cycle mac protocol for dynamic traffic loads in wireless sensor networks," in SenSys '08: Proceedings of the 6th ACM conference on Embedded network sensor systems. New York, NY, USA: ACM, 2008, pp. 1-14.

  15. Thank You Question ?

More Related