1 / 17

Setting Up a Tripod

Setting Up a Tripod. Unscrew the center knob at the collapsed tripod base to loosen, and then re-tighten it once all the legs are fully extended. Pull the leg locks up to adjust tripod to the desired height. Then press the leg locks in again.

reina
Download Presentation

Setting Up a Tripod

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Setting Up a Tripod

  2. Unscrew the center knob at the collapsed tripod base to loosen, and then re-tighten it once all the legs are fully extended.

  3. Pull the leg locks up to adjust tripod to the desired height. Then press the leg locks in again.

  4. This is what the tripod should look like when it is fully extended.

  5. Turn the handle to the Left to loosen for tilting the camera up and down. Make sure this is locked at a somewhat level position before securing the camera onto the tripod.

  6. The knob below the hot-shoe loosens to permit panning from left to right or vice-versa. Make sure this is also locked before securing the camera to the tripod.

  7. You have to unlock the hot-shoe in order to remove it from the tripod.

  8. You will have to wind the screw to the bottom of the camera before placing the hot-shoe back onto the tripod.

  9. The hot-shoe goes into the bottom of the camera.

  10. Be sure to put the bubble on the LCD side of the camera.

  11. Screw the hot-shoe on securely.

  12. Pull the hot-shoe lock open to put the hot-shoe into place.

  13. It is very important to make sure that the hot-shoe is locked tightly on top of the tripod and that the tripod is steady.

  14. Then you can level the tripod.

  15. With the tripod level, press the green button on the dial in to turn the dial to camera mode.

  16. Press the red circle to begin recording and you will see REC appear either through the viewfinder or on the LCD screen. Press the red circle again to stop recording and the letters STBY will appear.

More Related