WTP film

1. WTP movie H2o transfer printing films encompass a clear layer of polyvinyl liquor (PVA), that is printed having a assortment of decorations. The ink layer is then sealed. The PVA layer dissolves on speak to with drinking water. Thereafter, the seal is dissolved by an activator (a unique sort of solvent) and just the shade layer remains. The paint layer adheres on the workpiece immersed and behaves like a lacquer layer soon after drying. The best water temperature for your technique of printing h2o films is 32 ° C. In cold weather conditions up to 34 ° Celsius. The transfer water transfer film needs to be reduce on all sides at a distance of 1 cm to prevent winding when placing around the area from the drinking water. Remember to tend not to persist with tape since the film can not rise during the immersion procedure (In the event the PVA is dissolved, the movie "relaxes" and the surface area measurement increases minimally). Soon after the specified exposure time, spray the movie in a length of 20-30 cm while in the direction of crossover with activator of 25 to 45 g / m² (with regards to the cause, because highly printed movies require more activator). The workpiece could be immersed soon after approx. 15 seconds. All elements which are not made of Abdominal muscles plastic must be prepared just before diving (eg by lacquering). After approx. A single minute, the workpiece should be washed with scorching h2o at 42 ° C (don't make use of a robust h2o jet, areas of the movie might dissolve). The coloration shown might vary in the unique film with regards to the output unit. For the end result that's similar to the impression, the colour recommendation background ought to match the chosen h2o transfer print movie. Verify out this internet site: http://cursopinturahidrografica-wtp.com