190 likes | 249 Views
Thermo TPM-903B Set-Up. TPM-903B Transportable Portal Monitor. Thermo TPM-903B Un-Packing. TPM arrives in Wooden box with the blue bag or the rugged rolling case This may be used for storage of TPM Remove blue bag. Unzip bag to reveal TPM held by velcro straps. Thermo TPM-903B Placement.
E N D
Thermo TPM-903B Set-Up TPM-903B Transportable Portal Monitor
Thermo TPM-903B Un-Packing • TPM arrives in Wooden box with the blue bag or the rugged rolling case • This may be used for storage of TPM • Remove blue bag. • Unzip bag to reveal TPM held by velcro straps
Thermo TPM-903B Placement • Place crosspiece on floor • This is just to space feet • Place feet at same width
Thermo TPM-903B Assembly • Stand pillar on foot • Viewed from “Entry” side • Controller / Pillar “A” best on right • For safety best done with two
TPM-903B Detector Feet Mounting • Use washers • Tighten nuts tight • Letters to the inside
Thermo TPM-903B Both Detector Pillars • Stand up left pillar • “Letters” face in • “Plain” pillar best on left • Viewed from “Entry” side • Mount in same way as “master” pillar
Thermo TPM-903B Overhead Piece • Cable #1 to “A” • Cable #1 to “B” • Both #1 & #2 thru hole
Thermo TPM-903B Pillar Connections • Hold overhead above pillars • Attach cable #1 to controller pillar “A” • Attach cable #2 to plain pillar • Rest overhead on pillar tops
Thermo TPM-903B Controller Connections • Cable #1 to 1 • Cable #2 to 2
Thermo TPM-903B I/R People Sensor • Check “people sensor” direction • Set angle as desired
Thermo TPM-903B - Switch On Follow set up instructions. Switch on power switch. You will hear a test beep and the lamps will flash. TPM will cycle through a test screen and a background screen, then finish with an OK screen and a green light. • Green Light • Background counts • Occupancy Status • # of occupancies • Battery voltage • Date / Time • f
Thermo TPM-903B Start up Tests • Switch on • Check display • RAM “passed” • NVRAM “passed” • Check Red Light • Check Green Light • Check Sounder
Thermo TPM-903B “Ready” • Green Light • Background counts • Occupancy Status • # of occupancies • Battery voltage • Date / Time
Thermo TPM-903B - Operation • Set up a “hold line” 6-8 feet from TPM-903B • Operator stands by display • When display says OK/Ready operator instructs single users to walk through without pause • If no audible and visual alarm is noted after exit, operator calls through next user from hold line. • If the TPM-903B alarms, move user away to de-con zone and frisk user, then after alarm resets, call through next user • Use PRD/Frisker to find hot spot and/or a RIID to Identify Isotope.
Thermo TPM-903B Vehicle Kit • Any questions? • Call Mark Deacon • Cell # 440-487-6427 • Email mark.deacon@thermofisher.com