1 / 27

Chapter 10 cont.

Dimensioning and Tolerancing. Chapter 10 cont. Dimensioning Features (cont.) Hexagons and polygons. Should be dimensioned across the flats in a view that shows it in it’s true shape. Arcs. Dimensioned with a leader in a view where shown as it’s true shape

tana
Download Presentation

Chapter 10 cont.

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Dimensioning and Tolerancing Chapter 10 cont.

  2. Dimensioning Features (cont.)Hexagons and polygons • Should be dimensioned across the flats in a view that shows it in it’s true shape

  3. Arcs • Dimensioned with a leader in a view where shown as it’s true shape • Diameters-dimensioned with symbol before the value • Radii-dimensioned with capitol R before the value • Leader should theoretically extend through the center of the arc • Leader can physically extend through the center of the arc to help locate the arc center

  4. Center Marks • Center marks should be placed on all diameter features • Center marks should only be placed on radii that require center location

  5. Spherical features • Spherical radii dimensioned with an SR before dim value • Spherical Diameters dimensioned with an S before the dim value

  6. Contours • Shapes that are not defined as arcs • Dimensioned by locating points along the contour

  7. Locating a Point • Method of locating points that are not part geometry but are necessary to describe the shape • Commonly referred to as “point of intersection” or PI PI Often PI will be used to note point of intersection

  8. Notes for size featuresHoles Holes-dimensioned in views where they appear as circles or in a sectional view

  9. Dimensioning blind holes • Blind holes-a hole that does not go thru the part • Depth must be given in one of two ways

  10. Counterbore • One small thru hole for a fastener to pass through • One large hole to recess the head of a fastener below the surface of the part

  11. You will need to know how to place one style of these notes on a drawing

  12. Countersink • One small thru hole for a fastener to pass through • Large hole has angled sides to accept a countersink headed fastener • Fastener head sits flush with top of the part

  13. You will need to know how to place one style of these notes on a drawing

  14. Counterdrill • Combination counterbore and countersink You will need to know how to place one style of these notes on a drawing

  15. Spotface • Similar to a counterbore accept for the depth of the large hole • Large hole is a machined surface to provide a flat bearing surface for a fastener to clamp against • Depth is determined by machinist based on how rough the surface of the part is • Seen commonly on cast parts

  16. You will need to know how to place one style of these notes on a drawing

  17. Slotted Holes • Must define length and width (and location) • Choose a method based on what is important for part function

  18. Knurls • A pattern machined into parts to provide grip • Not shown in true detail on drawings • Defined by a note with a leader to show the area to be knurled

  19. Necks and grooves • Areas on cylindrical parts where the diameter changes for a certain length • Appear on turned parts

  20. Repetitive Features • When a part has more than one feature of the same size, they can be dimensioned with a note that specifies the number of features • Should only be used when it is obvious which features are the same size

More Related