1 / 27

University of Kansas: Mehdi Salehi, Stephen Johnson and Jenn-Tai Liang

Wettability alteration of carbonate rock mediated by biosurfactant produced from high-starch agricultural effluents. University of Kansas: Mehdi Salehi, Stephen Johnson and Jenn-Tai Liang Idaho National Laboratory: Sandra Fox and Gregory Bala 9 th International Wettability Symposium

teva
Download Presentation

University of Kansas: Mehdi Salehi, Stephen Johnson and Jenn-Tai Liang

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Wettability alteration of carbonate rock mediated by biosurfactant produced from high-starch agricultural effluents University of Kansas: Mehdi Salehi, Stephen Johnson and Jenn-Tai Liang Idaho National Laboratory: Sandra Fox and Gregory Bala 9th International Wettability Symposium Bergen, Norway. 18-19 September 2006

  2. Outline • Introduction • Surfactin and benchmark surfactants • Static adsorption • Aging procedure • Wettability tests • Conclusions • Future and ongoing work • Acknowledgments

  3. Introduction • Spontaneous imbibition of water is the main production mechanism in naturally fractured reservoirs (NFR) • NFRs are mostly oil-wet or mixed-wet (Roehl et al. 1985). • Secondary production is very low, especially if the fractures form a connected network (Allan et al. 2003) • Low-concentration surfactants can change the wettability of the reservoir rock to a more water-wet state, promoting the spontaneous imbibition of water • Cheap biosurfactant may be an economical option

  4. Oil Surfactant • Effectiveness of surfactant-based EOR depends on surfactant propagation through reservoir • Dilute solutions of biosurfactant assessed for: • effectiveness in mediating wettability of carbonate rocks • adsorption • Compared to similar benchmark chemical surfactant

  5. Biosurfactant • Surfactin • anionic cyclic lipopeptide • surfactant and antibiotic properties • Bacillus subtilis • grow on high-starch medium (agro-industry waste stream) • centrifuge to remove cells • HCl to precipitate surfactin • centrifuge and freeze-dry • re-dissolve in RO-water as required • Characterized by Schaller et al. (INL)

  6. Benchmark chemical surfactants • Similar charge • Comparable tail length • Prior study and/or use • Candidates: • sodium dodecylbenzene sulfonate (BIO-SOFT D40) • sodium dodecyl sulfate (STEPANOL) • sodium laureth sulfate (STEOL CS-330)

  7. IFT between surfactants and Soltrol 130 Selecting the chemical surfactant

  8. Materials • Benchmark surfactant: STEOL CS-330 (Stepan Co.) • Biosurfactant: Crude surfactin (INL) • Adsorbents (53 to 300 m) : • Miami oolitic outcrop (MI) • Bethany Falls oomoldic outcrop (BF) • Lansing-Kansas City oomoldic reservoir material (L7) from the Hall-Gurney Field in Russell County, KS. • Surfactant-ion selective combination electrode used to determine concentration of anionic surfactants in aqueous solution by potentiometric titration with Hyamine 1622.

  9. Potentiometric titration Modified after DIN EN 14480

  10. A C B Surfactant electrode .

  11. Static adsorption • Procedure: • 2.0 g crushed rock • 30 ml surfactant solution • shake for 24 h • centrifuge @ 3000 rpm for 30 min. • measure surfactant concentration before and after equilibrating with crushed rock • calculate specific adsorption (mg/g)

  12. Specific adsorption at various surfactant/adsorbent mass ratios

  13. STEOL CS-330 isotherms on BF rock

  14. STEOL and surfactin (30 ml) adsorption isotherms on 2.0 g BF and L7 rocks STEOL and surfactin isotherms on 2.0 g BF and L7 rocks .

  15. Adsorption results (I) • Higher adsorption on oomoldic material • higher specific surface area • Specific adsorption  as rock mass  • settling of crushed rock in the test tubes reduced contact with surfactant? • higher shaking rates  adsorption • mechanical scouring of surface

  16. Adsorption results (II) • Specific adsorption • surfactin > STEOL CS-330 • maximum adsorption density reached at a lower concentration • reflects the lower CMC of surfactin • Surfactin and STEOL CS-330 on both L7 and BF rocks exhibit the four regions seen in a typical adsorption isotherm

  17. Regions of typical adsorption isotherm Four regions of adsorption isotherm CMC . HMC After Tabatabai et al. (1993)

  18. Explanation for regions of adsorption isotherms After Somasunduran et al. in Sharma (1995)

  19. Wettability change • Clean crushed rocks • THF, chloroform, methanol, water • strongly water-wet • Age crushed rocks in crude oil • two weeks at 90C • strongly oil-wet • Change in wettability due to surfactants • contact aged rock with surfactants • assess wettability

  20. Qualitative wettability tests • Two-phase separation (Somasundaran & Zhang 1997) • 0.2 g of crushed rock • 20 ml RO-water • 20 ml Soltrol 130 • shake for 1 min by hand and allow to settle • material partitions between aqueous/non-aqueous phases • Flotation test (Wu et al. 2006) • 0.2 g of crushed rock • RO-water • oil-wet material floats

  21. LKC reservoir rock – two-phase separation and flotation tests

  22. Bethany Falls oomoldic outcrop - two-phase separation and flotation tests .

  23. Wettability tests results • Two-phase separation and flotation tests agree • Surfactin more effective than STEOL CS-330 in reversing the wettability of oil-wet crushed carbonate rocks.

  24. Conclusions • Standardize and report mass of rock and volume of surfactant solution used to develop adsorption isotherms • STEOL CS-330 and surfactin exhibit typical adsorption isotherms with four distinct regions • Surfactin has higher specific adsorption on carbonate rocks than STEOL CS-330 • Surfactin is more effective than STEOL CS-330 in altering wettability of crushed BF and LKC carbonates from oil-wet to water-wet state. • on both molar and w/w bases

  25. Ongoing and future work • Ongoing • Assess other chemical surfactants • Spontaneous/forced imbibition in cores • Future • Dynamic adsorption/desorption experiments • Economic analysis

  26. Acknowledgements • Co-authors: • Mehdi Salehi (PhD candidate, KU) • Jenn-Tai Liang (PI, KU) • Gregory Bala (Co-PI, INL) • Sandra Fox (INL) • Other team members • Karl Eisert (MS candidate, KU) • Vivian Lopez (Undergraduate, KU) • Financial support • Grant # DE-FC26-04NT15523 • United States Department of Energy (National Energy Technology Laboratory/Strategic Center for Natural Gas and Oil)

  27. Contact details • Stephen J. Johnson • The University of Kansas Tertiary Oil Recovery Project Learned Hall, Room 4165E 1530 W. 15th Street Lawrence, KS 66045-7609 • +1 (785) 864-3654 • +1 (785) 864-4967 • sjohn@ku.edu

More Related