1 / 27

Dr. Mike Nofziger Professor College of Optical Sciences University of Arizona

REU/RET Optics Research Workshop 2014 Workshop #3 Solar Energy, Solar Ovens Optical Detectors and Solar Cells. Dr. Mike Nofziger Professor College of Optical Sciences University of Arizona.

thina
Download Presentation

Dr. Mike Nofziger Professor College of Optical Sciences University of Arizona

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. REU/RETOptics Research Workshop 2014Workshop #3Solar Energy, Solar OvensOptical Detectors and Solar Cells Dr. Mike Nofziger Professor College of Optical Sciences University of Arizona Dr. Mike Nofziger 2014

  2. Workshop #3 Outline: ● Solar Energy - Basics of Energy - Our Sun - The solar spectrum - The greenhouse effect - ● Solar Ovens ● Optical Detectors● Solar Cells Dr. Mike Nofziger 2014 Workshop 3-1

  3. Basics of Energy: ● Two fundamental types of energy: - Potential Energy : “stored” energy (work could be done with this available energy) - Kinetic Energy : “working” energy (work is being done with this energy) ● Forms of Energy: - Light (radiant) - Heat (thermal) - Motion (kinetic) - Electrical - Chemical - Nuclear - Gravitational Dr. Mike Nofziger 2014 Workshop 3-2

  4. Basics of Energy: ● Renewable Energy Sources: - Solar energy → electricity or heat - Wind - Geothermal energy from heat inside the Earth - Biomass from plants - firewood, wood waste - ethanol from corn - biodiesel from vegetable oil - Hydropower from hydro-turbines at a dam ● Non-Renewable Energy Sources: - Fossil fuels - oil - natural gas - coal Dr. Mike Nofziger 2014 Workshop 3-3

  5. Basics of Energy: ● Energy is conserved - Scientifically speaking, “Conservation of energy” does not mean “saving energy”“Law of Conservation of Energy” - The total amount of energy in a closed system remains constant. - Energy does not disappear, or “get used up.” - Energy is changed from one form to another when it is used. Dr. Mike Nofziger 2014 Workshop 3-4 www.eia.gov

  6. Energy vs. Power: ● Energy is defined as the capacity for doing work. - Fundamental units of energy: - Joule, Calorie, British Thermal Unit (BTU)1 J = 0.23889 calories 1 J = 0.947816x10-3 BTU ● Power is defined as the rate of using energy: - Fundamental units of power: - Watt, Horsepower1 Watt ≡ 1 Joule/sec. 1 hp = 746 watts- Therefore, energy ≡ power x time- An equivalent unit of energy is:Watt·hour (Wh), kilo-Watt·hour (kWh) Units! (“love ‘em” or “hate ‘em”…..teach your students to “love ‘em”!) Dr. Mike Nofziger 2014 Workshop 3-5

  7. Energy per photon of light: where h is Planck’s constant h = 6.626x10-34 J-s Example of Power, Energy, and Photons/sec:Each photon of light carries a specific amount of energy:Energy and Power in a Laser Beam:“A typical red laser pointer emits 3-3 mW of power, at a wavelength of 650 nm. (For simplicity, assume the power is 1 mW)”• How much energy is delivered by this laser beam, in 1 sec?• How many photons per second are in this laser beam? Dr. Mike Nofziger 2014 Workshop 3-6

  8. Our Sun: ● The “ROY G BIV” solar spectrum:● The Ideal Blackbody (solar) spectrum: Dr. Mike Nofziger 2014 Workshop 3-7

  9. Our Sun: ● The “Real” solar spectrum: ● The sun delivers ≈ 1000W/m2 to the surface of the Earth! ● The Earth receives more energy from the Sun in just one hour than the world uses in a whole year. http://org.ntnu.no/solarcells/pages/Chap.2.php Dr. Mike Nofziger 2014 Workshop 3-8

  10. Our Sun: ● The Ability to harness solar energy by concentrating it: Dr. Mike Nofziger 2014 Workshop 3-9

  11. Our Sun: ● The Ability to harness solar energy by using solar cells: Dr. Mike Nofziger 2014 Workshop 3-10

  12. Basis for the Heating in a Solar Oven (a.k.a. a “Greenhouse Effect”):• The wavelength of peak output from a blackbody (an ideal emitter, much like our sun) is given by: where T(K) = T(°C) + 273°• The surface temperature of our sun is ≈ 6000K• The wavelength where our sun emits most energy is, therefore:• 500 nm is in the green portion of the visible spectrum.• The peak sensitivity of human (daylight) vision is at 550nm………?! Dr. Mike Nofziger 2014 Workshop 3-11

  13. Basis for the Heating in a Solar Oven (a.k.a. a “Greenhouse Effect”):• The wavelength of peak output from a solar oven cavity, at T≈ 400°F: Dr. Mike Nofziger 2014 Workshop 3-12

  14. Basis for the Heating in a Solar Oven (a.k.a. a “Greenhouse Effect”):• Typical “window” material for a student solar oven is a single sheet of Mylar (Xerox Overhead Transparency):• High transmission in the visible/near IR spectrum• Low transmission in the thermal IR spectrum (i.e. at 6 μm) - The cavity absorbs visible light but has trouble emitting (radiating) thermal energy at 6 μm, therefore the cavity heats up. • Basic “Greenhouse Effect” (car interiors, the Earth, etc.): Fig. A.3. Infrared transmission spectrum of one layer of Mylar for wavelengths from 2 to 18 micrometers Dr. Mike Nofziger 2014 Workshop 3-13

  15. Photoconductors—Physical Construction: “Official Symbol” Known as: “Photoresistors”, “Light-Dependent Resistors (LDR)” “Photocells” …………. Photoconductors! Most common semiconductor material used for detection of visible light is CdS (also CdSe). Dr. Mike Nofziger 2014 Workshop 3-14

  16. Photoconductors—Physical Construction: Ref: “Photoconductive Cells” Dr. Mike Nofziger 2014 Workshop 3-15

  17. Photoconductors—Current-Voltage Characteristics: …where fc refers to “foot-candles” (a measure of the amount of visible light per unit area) The resistance is the inverse of the slope of this curve. Dr. Mike Nofziger 2014 Workshop 3-16

  18. Photodiodes—Physical Construction: “Official Symbol” A 40 Gb/s “Optical Receiver” !! Dr. Mike Nofziger 2014 Workshop 3-17

  19. ● p-n junction (p-side ≡ “anode”, n-side ≡ “cathode”)● Built-in electric field (depletion region) separates the electrons and holes (electrons → p-side, holes → n-side) ● Photons absorbed (ideally in or near the depletion region) create electron-hole pairs ● Built-in electric field separates the electrons and holes before they recombine, producing a photocurrent (electrons → n-side, holes → p-side)● I-V curve is very non-linear ● The photocurrent is linear with photon flux over 7-decades! ● Most common semiconductor material used to make photodiodes (for detection of visible light) is Silicon (Si). Photodiodes—Basic Properties: Dr. Mike Nofziger 2014 Workshop 3-18

  20. Photodiodes—Basic Physics: Dr. Mike Nofziger 2014 Workshop 3-19

  21. The “Shockley diode equation” Io is the reverse saturation current V is the voltage across the junction Photodiodes—Current-Voltage Characteristics: Photocurrent generated by irradianceEe(W/m2) Photocurrent generated by optical power ϕe (W) Dr. Mike Nofziger 2014 Workshop 3-20

  22. Photodiodes—Current-Voltage Characteristics: Dr. Mike Nofziger 2014 Workshop 3-21

  23. Photodiodes—Use in an Electrical Circuit: Transimpedance Amplifier (“TIA”) • converts current to voltage Operated at V = 0 “zero-bias”: Output is very linear over 7-decades of flux Operated at –V “reverse-bias”: Capacitance decreases, speed increases Operated at I≈0 “open-circuit”: The open-circuit voltage is logarithmic with flux: NOT the preferred way to operate a photodiode! Dr. Mike Nofziger 2014 Workshop 3-22

  24. Photodiodes—Use in a Commercial “TIA”: Thorlabs PDA 200 Photodiode Amplifier (“TIA”) Dr. Mike Nofziger 2014 Workshop 3-23

  25. Basics of Solar Cells:● A solar cell is a Photovoltaic (“PV”) detector: - is made of Silicon (not silicone!!) - absorbs light from ≈ 350nm – 1100nm - the absorption of light “frees up” electrons - This creates a voltage at the terminals of the cell (the “Open-Circuit” voltage) - If a load resistor is connected to the cell, a current will flow (the “Photocurrent”) - If the cell’s terminals are shorted, the maximum current will flow (the “Short-Circuit” current) Dr. Mike Nofziger 2014 Workshop 3-24

  26. Basics of Solar Cells:● The IV Curve of a PV detector is given by:● The Photocurrent of a PV detector is given by: Dr. Mike Nofziger 2014 Workshop 3-25

  27. Basics of Solar Cells:● The Power (Watts) that the cell can produce is given by:● Because of internal resistance in the cell, the maximum power you can generate is across a load resistance equal to the internal resistance.www.keithley.com Dr. Mike Nofziger 2014 Workshop 3-26

More Related