1 / 23

Making a Laminated Rolling Pin

Making a Laminated Rolling Pin. Mike Rude. Laminated Rolling Pin. Preparing the Lumber for Lamination. Select 1 to 2.5 inch thick hardwood lumber Stock should be 2.5 by 14 inches Dry lumber only Small pores Plane the stock so it is smooth and parallel

wiley
Download Presentation

Making a Laminated Rolling Pin

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Making a Laminated Rolling Pin Mike Rude

  2. Laminated Rolling Pin

  3. Preparing the Lumber for Lamination • Select 1 to 2.5 inch thick hardwood lumber • Stock should be 2.5 by 14 inches • Dry lumber only • Small pores • Plane the stock so it is smooth and parallel • Arrange the pieces for color pattern

  4. Preparing the Lumber for Lamination

  5. Preparing the Lumber for Lamination Glue 5 or 6 Pieces at a time on a Diagonal for 12 inch Final Size

  6. Preparing the Lumber for Lamination Glue and Clamp all the Groups Together

  7. Cutting the Blanks Trim Both Sides on a Table saw

  8. Cutting the Blanks Cut the Lamination into 2.5 inch Square Blanks Glue First-cut Wedge onto the End

  9. Cut the Blanks Handle – 1.5 x 1.5 x 4 Shaft – 1 x 1 x 7 Rolling pin – 2.5 x 2.5 x 12

  10. Turning the Body Mark the Center of Both Ends

  11. Turning the Body Mount the Blank and Rough Turn

  12. Turning the Body Drill a 2 inch deep ½ inch Hole for Shaft

  13. Turning the Body Reverse, Rough, and Drill the Other End

  14. Turning the Body Mount the Blank on ½ Inch Pin Chuck Finish Turn to 2 ¼ Inch Diameter

  15. Turning the Body Check for Size and Flatness

  16. Turning the Handles Mount and Drill 5/8 inch Hole for Shaft

  17. Turning the Handles Use a Cone Center and Rough Turn the Handle True the End

  18. Turning the Handles Make a Jam Chuck to Mount the Handle

  19. Turning the Handles Finish Turn, Sand, and Apply Finish Lubricate Ends with Paraffin

  20. Turning the Shaft • Mount the Shaft with a Spur Drive • Turn Shaft to 5/8 Inch • Measure Handle and Mark for ½ Inch Section • Match Shaft End to Handle Body

  21. Turning the Shaft • Sand and Lubricate 5/8 inch Shaft Section • Turn Shaft End, Sand, and Finish

  22. Completed Handle Note Slight Protrusion of Shaft Body so Handle Can Spin

  23. Ready to Assemble

More Related