Physics 430: Lecture 12 2-D Oscillators and Damped Oscillations

1. Physics 430: Lecture 12 2-D Oscillators and Damped Oscillations Dale E. Gary NJIT Physics Department

2. 5.3 Two-Dimensional Oscillators • It is trivial to extend our idea of oscillators to other dimensions. For example, the spring arrangement in the figure at right oscillates in two dimensions. • In general, the springs in the x and y directions could have a different spring constants • Note that these springs may represent binding forces of an atom in a molecule or crystal. • If the spring constants are the same, the oscillator is called isotropic, and there is a single frequency of oscillation • There are two equations of motion, one for each dimension, given by • Although the solutions are the same for x and y, the constants of integration, which depend on the initial conditions, and not the same (in general):

3. y y y x x x Isotropic Oscillator • If we redefine the origin of time to coincide with the time that, say, the x position is at its maximum, this becomes where d is the relative phase d = (dy-dx). • Consider a ball bearing in a bowl. It may oscillate in only one direction, i.e. in the x direction or the y direction. This motion would correspond to the above equations when the constant Ay = 0 or Ax = 0, respectively. • The ball could go in a straight line at an angle to the x axis, i.e. in both x and y. That would correspond to Ax = Ay, andd = 0. • The ball could go in a circle about the bottom of the bowl, which would correspond to Ax = Ay, andd = p/2, in one direction, or d = -p/2 in the other direction. • Some other possibilities: d = 0 d = p/4 d = p/2

4. Anisotropic Oscillator • As noted before, in general, the springs in the x and y directions could have a different spring constants (How could we do this in the bowl and marble case?) • In that case, the oscillation frequencies would be different in the two directions and the oscillator is called anisotropic (differs depending on direction). We can easily write down the solution as: • You can play with a java applet to see the “orbits” for this case. Click here

5. resistive force spring force 5.4 Damped Oscillations • Recall when we were discussing the drag force, that we characterized it as either being proportional to v, or to v2. A drag force, or other resistive force in an oscillator leads to the oscillations dying out after awhile, a phenomenon we call damped oscillations. • Let’s investigate a damped oscillator whose damping is proportional to v, or • For a damped spring, for example, our equation of motion becomes • Writing it to emphasize that it is homogeneous: or… • For later convenience, we will substitute where b is called the damping constant. Large b => large damping. • As usual, we will also write

6. Damped Oscillator Equation • With these substitutions, our damped oscillator equation of motion becomes • This is the starting point for our complete discussion, which will be based on the solutions to this equation in various limits. You may already know how to solve such an equation in the general case. • The solution to such a linear equation is to assume a solution of the form which, when substituted into the equation, gives and after cancelling the common term, we have what is sometimes called the auxiliary equation: • This reduces the solution to that of solving a quadratic in r, which calls for use of the quadratic equation. The two solutions are: • The general solution is found by a linear combination of and , i.e.

7. e-bt Undamped and Weakly Damped • To understand the physics captured in the general solution let’s look at some limits. • For no damping at all (b = 0), we recover the usual solution for simple harmonic motion: • Now consider the case of weak damping (b < wo). This case is easiest to visualize if we write where • When the damping is small, we can think of w1 as a small correction to the undamped oscillation frequency wo. The complete solution is • Graphically, this looks like the plot at right. • The oscillation damps with an envelope given by the leading term e-bt. Thus, here b acts as a decay parameter. note, oscillation frequency is slightly lower

8. x(t) t Strong Damping • The general solution has a qualitatively different behavior in the limit of strong damping (b > wo), sometimes called overdamping. In this case, the radical is purely real, so we may as well leave the solution in its original form • The lack of a complex exponential is a clue that there is no real oscillation involved. In fact, both terms decrease exponentially and the motion looks like: • Decay parameter (slowest decay term) is long-term behavior decays as x(t) t initial conditions xo = 0, vo 0 initial conditions xo 0, vo= 0

9. Critical Damping • The last limit we want to discuss is critical damping, when b = wo. In this case, there is a mathematical issue that arises. Now our two solutions become one solution, r1 = r2. • Mathematically, we have a problem, since with only one solution, we have only one arbitrary constant, which is not sufficient—it does not give a complete solution. • Fortunately (and in general), when the auxiliary equation gives a repeated root, we can find another solution (as you can easily check) • The general solution is then a linear combination of our two solutions: • The graph of the solution qualitatively looks like the overdamped case, but the decay parameter (b = wo) is larger (i.e. the decay is faster). In fact, in the critical damping case the decay is faster than in any other case. Obviously, if you want to keep something stable against oscillations you want to arrange for it to be critically damped.

10. decay parameter wo b A Closer Look at Decay Parameters • The decay parameters that govern the drop in amplitude at long times are: • This dependence can be graphed as below: