1 / 4

Trim Fwd Spar End Brackets July 6, 2009

Trim Fwd Spar End Brackets July 6, 2009. 7H2-2, Horizontal Stab Rear Spar. Corner of Forward Spar End Bracket, marked for trimming. Note that the view here is with forward side to edge of table, bottom is to top, looking inboard. 7H1-2, Stab Full Rib.

anoush
Download Presentation

Trim Fwd Spar End Brackets July 6, 2009

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Trim Fwd Spar End Brackets July 6, 2009 7H2-2, Horizontal Stab Rear Spar Corner of Forward Spar End Bracket, marked for trimming. Note that the view here is with forward side to edge of table, bottom is to top, looking inboard. 7H1-2, Stab Full Rib http://www.zenith.aero/profile/WayneBartlett

  2. Trim Fwd Spar End Brackets July 6, 2009 Forward Spar End Bracket (removed), with mark for trimming (see inset) Inset Rough cut was made with snips, and steel file used to clean up and round off edges. http://www.zenith.aero/profile/WayneBartlett

  3. Trim Fwd Spar End Brackets July 6, 2009 7H2-2, Horizontal Stab Rear Spar Edge of bracket now conforms to bottom-edge curve of full rib where it meets the bracket. Forward spar end bracket reassembled to forward spar 7H1-2, Stab Full Rib This same procedure was performed on the other forward spar end bracket, at the other end of the spar. http://www.zenith.aero/profile/WayneBartlett

  4. Summary of Work to This Point July 6, 2009 Done Rudder: - Assembled, in storage - Forward spar drilled for ribs and rivets - Lower doubler drilled for rivets - Upper doubler drilled for rivets - Front horizontal stab attach brackets made - Locate and drill two rear ribs for attachment to spar - Locate and drill nose rib for attachment to spar - Make end rib attach brackets - Locate and drill end rib attach brackets - Locate and drill horizontal stab front mounts - Finish drilling holes in end brackets for forward stab - Locate and drill upper and lower doublers to rear spar - Locate and drill rear ribs to rear spar Tail: - Trim forward spar end brackets to match curve of full rib at meeting point Tail: - Confirm that forward tips of full ribs and nose rib are co-planar - Locate and drill forward spar end brackets for attachment to full spar Done Here Next Up http://www.zenith.aero/profile/WayneBartlett

More Related