310 likes | 494 Views
Street Rod Jeopardy. Typical passenger car tire inflation pressures are about A. 12-22 PSI B. 28-35 PSI C. 40-100 PSI 10. You get a flat while traveling, the first step in changing a tire is to A. Raise the tire off of the floor B. Remove the nuts
E N D
Typical passenger car tire inflation pressures are about A. 12-22 PSI B. 28-35 PSI C. 40-100 PSI 10
You get a flat while traveling, the first step in changing a tire is to A. Raise the tire off of the floor B. Remove the nuts C. Deflate the tire D. Loosen the nuts 20
When mounting a tubeless tire, first inflate the tire to A. Recommended Pressure B. Fill out the sidewall C. About 40 PSI D. About 100 PSI 30
To remove a tire from the rim, first • A. Deflate the tire • B. Remove the nuts • C. Remove the tube • Apply pressure on the tire bead • 40
Tires are constructed of • One type of rubber and steel • One type of rubber and fabric • Many types of rubber • Many types of rubber, fabric and steel • 50
Oil should be changed every_____miles • 100 • 1000 • 5000 • 25000 10
What product is used on dashboards? A. Quick Silver B. Armour All C. Rain-X D. Black Magic 20
Daily Double What must you do next after compounding a car? A. Apply a clear-coat B. Wax C. Wash D. Apply Rain-X DD
Which of the following is a type of car wax? • Carnuba • Carborumdum • Carbide • Rain-X 40
Many tires have tread wear indicators, which are • A series of warning lights on the instrument panel • Special types of valve stems • Filled- in section of tread grooves • 50
In self-adjusting drum brakes, the adjustment takes place • A. when the car is backed up and • then braked • B. Every time the brake pedal is • released • As the parking brake is applied • 10
In a disc brake, the part that holds the brake pads on each side of the disc is called the • A. rotor • B. caliper • piston • 20
The purpose of using a dual brake master cylinder is • A. to make the pedal easier to push • B. to provide longer brake life • that if one section fails, the other section can still provide braking • 30
Which statement is true of front disc brakes • A. it is where the parking brake is mounted • B. they squeeze the rotor • C. they have return springs • they do not shed water after driving through puddles • 40
Antilock systems use mechanisms at each wheel that A. make all wheels skid the same amount B. relieve hydraulic pressure at the wheels that are about to lock C. keep the front brakes from applying until the rear brakes apply 50
The link between the rear axle and the transmission is the • Driveshaft • Spring • Shifter 10
Which fluid is checked with the engine running? • Transmission • Engine oil • power steering • brake 20
The three basic types of springs are A.rubber, air, and coil B.leaf, coil, and torsion bar C.leaf, torsion bar, and rubber 30
Give the correct order of socket sizes • ¼”, 3/8” , 5/16”, ¾” • ¼”, 3/8”, 5/8”, ¾” • ¼” 3/32”, 9/16”, ½” 40
On rear-wheel brakes, which direction is the star-adjuster gear closer to A. Side B. Rear C. Front D. Doesn’t matter 50
Which of the following tools is used to force a piston back into the caliper’s bore on a front-disk brake? • C clamp • pair of channel-lock pliers • large punch and rubber hammer • rubber-tip blowgun 10
The number 10.090 cast into the brake drum refers to the • Minimum diameter of the drum • discard diameter • original size of the drum • manufacturer’s part number 20
The type of disc brake calipers found on most american automobiles is • single-piston floating • Two-piston fixed • Two piston floating • Single-piston fixed 30
If the brake pedal is hard to depress on a vacuum power brake system, the most probable cause would be • Too much vacuum • Loss of vacuum • Loss of brake fluid • Worn-out brake shoes or pads 40
When replacing the left front caliper on a diagonally split brake system, the correct bleeding sequence is • Left front, rear right • right front, left front • right rear, left front • none of the above 50
Wrong Answer Back to the question
You Are Correct! Back to the board
Final Jeopardy Category: Auto Detailing What is the main disadvantage to washing your car in the sun?