1 / 31

EMISSION STANDARDS IN LIGHT AND HEAVY VEHICLES

EMISSION STANDARDS IN LIGHT AND HEAVY VEHICLES. INTRODUCTION. Emission requirements in Europe since 1970 US and some European countries (Sweden, Norway and Austria) introduced first Current emission regulate NOX,HC,CO & PM Standards are represent by Euro & followed by no.

eara
Download Presentation

EMISSION STANDARDS IN LIGHT AND HEAVY VEHICLES

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. EMISSION STANDARDS IN LIGHT AND HEAVY VEHICLES

  2. INTRODUCTION • Emission requirements in Europe since 1970 • US and some European countries (Sweden, Norway and Austria) introduced first • Current emission regulate NOX,HC,CO & PM • Standards are represent by Euro & followed by no. • For motorcycles & mopeds and for engines of non road machinery

  3. ROAD TRAFFIC’S SHARE OF EMISSION

  4. EMISSION STANDARDS

  5. EU STANDARDS FOR HEAVY VEHICLES

  6. TEST CYCLES • Emissions measured by standardized test cycles • For light vehicles in g/Km • For heavy vehicles in g/kWh • For light vehicles transient cycle • Heavy vehicles both transient and stationary cycle • ETC,ESC,European load response (ELR), Enhanced Environmentally vehicles(EEV)

  7. EUROPEAN TRANSIENT CYCLE(ETC) • FIGE transient cycle • Road cycle measurement of heavy duty vehicles • 3 parts – urban , rural , motorway driving – total 1800s – each 600s • city driving max speed 50 km/hr, frequent starts, stops, and idling • rural driving starting with a steep acceleration segment (avg-72km/hr)

  8. CONTD… 3. Motorway driving with average speed of about 88 km/h • The cycle in two variants: a) As a chassis and b) An engine dynamometer test.

  9. EUROPEAN STATIONARY CYCLE(ESC) • Emission certification of heavy duty diesel engine • Engine is tested on dynamometer over steady state modes • The specified speed held within ±50 rpm and the specified torque held within ±2% of max torque • final results in g/kWh

  10. LIGHT VEHICLES • Road vehicles under 3.5 tonne (both passenger cars & commercial vehicles) • Auto-oil-program • Emission control increased the quality of fuel (eg; sulphur-150ppm to 10ppm within 2009) • NOX is controlled in PV • Particulates are controlled in DV

  11. EU STANDARDS FOR LIGHT VEHICLES

  12. HEAVY VEHICLES • Vehicles heavier than 3.5tonnes • EuroI-1992,EuroII-1995,EuroIII-2000, EuroIV-2005,EuroV-2008 • Main difference b/w Euro IV and Euro V • Environmentally friendly vehicles as well as for on-board diagnostic systems (OBD) enhanced it

  13. EU STANDARDS FOR HEAVY VEHICLES

  14. FUTURE EMISSION STANDARDS • Motor Vehicle Emissions Group Commission • German Environment agency (UBA) published new proposal for ES:- Passenger cars: 1. Emission requirements should be fuel-neutral 2. Particulate requirement should be strengthen by a factor 10 3. NOX strengthen by a factor of 3 4. Summation value for NOx + HC replaced with an HC limit

  15. CONTD… Heavy vehicles:- 1. Fuel-neutral requirements 2. Particulate standards for 2008 3. NOx requirement for 2008 are halved & then halved again in 2010 • Current weight-based standards with maximum no of particles within size range • Tax incentives to vehicles that comply with requirements

  16. FACTFILE:EMISSION CONTROL Petrol-driven passenger cars • Emission consist of NOX and unburnt HC • Three-way catalytic convertor • 300-400’C to start the catalytic convertor Diesel-driven cars • Nitrogen oxides • Particulates • Combined methods

  17. POPULAR EMISSION CONTROL DEVICES • HC as a result of vaporization of gasoline • Clean air act in 1977 • Feedback fuel control system • Oxygen sensors in exhaust • Some of the popular emission control system are explained

  18. Flash CATALYTIC CONVERTOR • It oxidize CO & HC using palladium & platinum as catalyst separatingoxygen than adding • It cannot operate in presence of lead • Industrial application to avoid harmful emissions • Ideal byproducts of automobile engine are CO2, H2O, and some N2 • Standard subcomponents of catalytic oxidizers include a line burner, catalyst bed, and heat exchanger.

  19. PCV VALVE • Take vapors from crankcase • Recirculation of air through crankcase • Dilute air/fuel mixture • Increase life of oil and engine • life of valve and filter is around 30000 to 50000 miles • If the valve or system is clogged, it will create engine oil leak

  20. EGR VALVE • Reduce emissions of oxides of N2 (1972) • How oxides of nitrogen formed? • Thought of a fire extinguisher to cool the combustion chamber • How CO2 & water (plus zillion other noxious chemicals) cool combustion chamber & prevent the formation of NOX • External EGR and Internal EGR valve

  21. EVAPORATIVE CONTROLS • To dispose of fuel vapors created in fuel system • Improper operation may cause rich driveability • Maintain stable fuel tank pressure • Due to evaporation fuel vapors are created • Stored vapor fuel is added to the incoming air/fuel mixture

  22. AIR INJECTION AIR INJECTION • The air injection system supplies air to the exhaust stream to promote additional burning of exhaust gases such as hydrocarbons (abbreviated as HC) and carbon monoxide (abbreviated as CO). • catalytic converter to further reduce HC, CO and oxides of nitrogen (NOx), a major contributor to photochemical smog

  23. TURBOCHARGER

  24. TURBOCHARGER • It’s a part of advanced clean diesel system • Increase diesel efficiency • What is a turbocharger? • How common rail direct injection and turbocharging increases efficiency • Turbochargers and advanced

  25. ABOUT BHARAT STANDARDS • Automotive Research Association of India (ARAI) decided to implement Bha-III • The gasoline vehicles were being tested for idle carbon monoxide emission and diesel vehicles for free acceleration smoke. • Four metros— Mumbai, Kolkata, Chennai, New Delhi — and the mini metros — Bangalore, Hyderabad, Ahmedabad, Pune, Surat, Kanpur and Agra.

  26. EURO STANDARDS FOR PETROL CARS

  27. EURO STANDARDS FOR DIESEL CARS

  28. EURO vs.US/JAPAN STANDARDS

  29. MERCEDES-BENZ BIONIC CAR

  30. TECHNICAL DATA • Vehicle Type: Mercedes-Benz concept car • Intake system: Common-rail direct injection, particulate filter, Selective catalytic reduction (SCR) • Engine: 4-cylinder Diesel engine • Horsepower: 140 hp • Torque: 300 Nm @ 1,600 – 3,000 rpm • Transmission: AUTOTRONIC continuously variable automatic transmission

  31. DISCUSSION

More Related