1 / 9

1600 Series Operation (See Installation and Operation Manual for detailed instructions)

1600 Series Operation (See Installation and Operation Manual for detailed instructions). FoamPro 1600 Series. Fully automatic Class A foam ONLY Proportions between 0.1% to 1% Flowmeter standard (1", 1-1/2" or 2" tee) Operators control panel. Foam Tank. Line Strainer. Water Tank.

garciamichael
Download Presentation

1600 Series Operation (See Installation and Operation Manual for detailed instructions)

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. 1600 SeriesOperation (See Installation and Operation Manual for detailed instructions)

  2. FoamPro 1600 Series • Fully automatic • Class A foam ONLY • Proportions between 0.1% to 1% • Flowmeter standard (1", 1-1/2" or 2" tee) • Operators control panel

  3. Foam Tank Line Strainer Water Tank Water Pump Electronic DirectInjection Proportioner Check Valves Flowmeter Multiple Discharges

  4. Features And Operations • Controller includes: • Operating instructions • On/Off switch • Injection rate control • Adjustable from 0.1%-1.0% • System Status Light

  5. Features And Operations (cont.) • System Status Light Codes: • Light flashes then goes out • System ready to operate • One flash per second • Simulated flow mode engaged • Remove power; disengaged automatically • Solid light • No concentrate • Two flashes per second • Concentrate level low • 5 flashes per second • Electrical error

  6. Features and Operations (cont.) Motor driver module Simulated flow momentary switch. Up once, engages. Up again, disengages Circuit breaker switch “UP” for normal operation

  7. Purging Air • Enter “SIMULATED FLOW” • Valve to “CAL/FLUSH” • Turn panel switch “ON” • Run pump until concentrate flows from dump line

  8. Purging Air (cont.) • Turn control panel to “OFF” position • Return valve to “INJECT” • Exit “SIMULATED FLOW” by switching momentary switch up

  9. Foam concentrate pump • Grease fitting every 8 hours of operation Maintenance • Foam concentrate strainer • Clean out regularly • If little or no foam concentrate is injected while system is running, check for clogged strainer • Purge air from foam pump afterwards

More Related