1 / 13

Workshop Design of Experiments

Workshop Design of Experiments. Design Exploration. Workshop. Goal Showing Design Exploration DOE scenario, and creating response charts Model Description The boundary conditions have been applied as shown here. Model is created in Design Modeler Input parameters

harper
Download Presentation

Workshop Design of Experiments

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. WorkshopDesign of Experiments Design Exploration

  2. Workshop • Goal • Showing Design Exploration DOE scenario, and creating response charts • Model Description • The boundary conditions have been applied as shown here. • Model is created in Design Modeler • Input parameters • ds_cutout – geometry parameter from DM • Bearing load • Output parameters • Mass • Equivalent stress • Total deformation ds_cutout

  3. Workshop 1. File>Open>Link1.dsdb 1 2. Verify all your input and output parameters by double click on parameters set. 2 Input parameters Output parameters 3 3. Return to the Project

  4. Workshop 4. Double click on “Response Surface” to start DOE study 4 5. Double click on DOE Outline of DOE shows input and output parameters 5

  5. Workshop 6. Highlight parameter in “Outline of Design of Experiments” 6 7. In Properties of define type of the design variable and also set up lower and upper bounds. Ds-cutout, continues variable bounds from 4.5-5-5.5 7 8. Bearing load, continues variable bounds from 9-10-11 8

  6. Workshop 9. Highlight DOE -DOE type is set to Central Composite Design by default 9 10 10. Preview and Update design points 11 11. Click on Show Progress to expand Status bar

  7. Workshop Table of DOE shows 9 design points 13 12 13. Select to show Total deformation vs Design Points 12. Click on Design Points vs Parameter

  8. Workshop 14 14. Return to Project Page 15. Double click on Response Surface 16. Update Response Surface 15 17. Double click on Response 17 16

  9. Workshop 18. Set Mode to 2D and X and Y axis as shown 18 19. Switch Mode to 3D and Set X, Y, and Z axis as shown 19

  10. Workshop 20. Click on spider and local sensitivities to plot charts 20

  11. Workshop 21. RMB on the Response surface Insert as Response Point 21 22. RMB on desired Response point and Insert it as Design Point 22 Your Response point should not be the same as one shown here

  12. Workshop 23. Return to Project Page 23 24. Double click on Parameter set 25. Update all design points 24 25 26. RMB on DP1 and Copy inputs to current and Updated selected Design Point 26 27. Return to Project Page 27

  13. Workshop 28. Double click on Solution 28 Check the results in Mechanical

More Related