70 likes | 179 Views
Use of Impinging Sprays to Reduce Engine Emissions. Achuth Munnannur and Prof. Rolf D. Reitz. Acknowledgement: S C Johnson Wax. Why Impinging Sprays?. Spray - spray impingement has been found to be quite beneficial for enhanced atomization and mixing.
E N D
Use of Impinging Sprays to Reduce Engine Emissions Achuth Munnannur and Prof. Rolf D. Reitz Acknowledgement: S C Johnson Wax
Why Impinging Sprays? • Spray - spray impingement has been found to be quite beneficial for enhanced atomization and mixing. • Application areas are diverse - rocket motors, internal combustion engines, household and agricultural sprays….. • Is of special interest to I C engines because spray-spray impingement can, • produce ultra-low NOx and low smoke (SAE 1999-01-0185) • possibly reduce HC emissions and fuel consumption (SAE 2001-01-1892)
Major Modeling challenges • In this application, reliable modeling of drop-drop collisions is extremely important. • The collision model used in current CFD codes (O’Rourke (1981)), including KIVA, is inadequate since it considers only a limited number of collision outcomes. Further, it is very dependent on gas phase mesh-size. • The current project will improve the collision sub-model such that it considers all major regimes of binary droplet collisions, trying also to achieve adequate grid independency in collision calculations. The improved model will be used for studying the effect of impinging fuel sprays on engine emissions.
(Drops cannot expel intervening gas film) (Kinetic energy of unaffected part vs. Surface energy) (Drops form a combined mass) (Reflexive energy vs. surface energy) Modeling New Regimes Separation processes modeled considering temporal evolution of a ligament that eventually breaks-up by capillary instability or retracts to form a single satellite.
Results from the new collision model Experiment Simulation Propanol-2 drop streams (Brenn et al. (2001)) – drops enter from top Ethanol droplets colliding at atmospheric pressure (Estrade et al. (1999))
Results from the new collision model Colliding steams of Stoddard Solvent (Hung (1998)) Collision angle 10° Collision angle 20°
Future Work • Achieving adequate grid independence • Extensive validation of the model • Use of the model for simulations in engine conditions including impinging spray applications