Opto-Chip 2010 Summary of Contents

1. Opto-Chip 2010Summary of Contents D.S.S. 3/3/2010

2. Band-gap Reference DAC Bias Circuit DAC (4X) • DAC + Band-gap Reference + Bias • Acquired from CERN • Used to remotely set individual VDC modulation current

3. 16 Channel Mux. Spare VDC VDC (3) VDC with pre-emphasis (2) VDC with pre-emphasis (1) • VDC • 4 channels, each capable of 5Gb/s operation • 1 channel designated as spare, contains mux to optionally route LVDS receiver signals from other 3 channels to output • 2 channels with pre-emphasis drive capability

4. DORIC • 4 channels • 3 fixed speed (40Mb/s) • 1 multi speed (40, 80, 160, or 320Mb/s) • 1 channel designated as spare, allows routing of amplified PIN signal from the other 3 channels to itsclock and data • Fixed speed channels include a FEI4 command decoder (from Roberto Beccherle) • Used to set channel routing in VDC / DORIC • Used to set VDC DACs • control of opto-chip based on majority vote of the three command decoders FEI4 Command decoder Fixed Speed Doric (1) FEI4 Command decoder Fixed Speed Doric (2) FEI4 Command decoder Fixed Speed Doric (3) Multi Speed Doric / SPARE

5. Power on reset circuit Control Logic • Opto-Chip Control Logic • Interfaces opto-chip controls to the 3 FEI4 command decoders • Contains SEU tolerant DICE latches from FEI4 • Test port included to allow over-ride of command decoder control • Power on reset circuit to set default VCSEL current to 10mA

6. CML Driver with Pre-Emphasis • Capable of 5Gb/s operation • Programmable pre-emphasis / main drive amplitude • Programmable pre-emphasis width CML Driver