1 / 31

Minimal criteria for Rapid Phase Transition explosion of cryogenic gases Roberto Bubbico 1 , Ernesto Salzano 2

Minimal criteria for Rapid Phase Transition explosion of cryogenic gases Roberto Bubbico 1 , Ernesto Salzano 2. 1 Dipartimento di Ingegneria Chimica Università di Roma “La Sapienza” Roma, Italy 2 Istituto di Ricerche sulla Combustione Consiglio Nazionale delle Ricerche Napoli, Italy.

obert
Download Presentation

Minimal criteria for Rapid Phase Transition explosion of cryogenic gases Roberto Bubbico 1 , Ernesto Salzano 2

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Minimal criteria for Rapid Phase Transition explosion of cryogenic gasesRoberto Bubbico1, Ernesto Salzano2 1 Dipartimento di Ingegneria Chimica Università di Roma “La Sapienza” Roma, Italy2 Istituto di Ricerche sulla Combustione Consiglio Nazionale delle Ricerche Napoli, Italy

  2. Introduction • Liquefied natural gas (LNG) market is increasingly expanding • Storage, handling and transportation of large volumes is involved • Large-scale hazards ??

  3. General data • LNG is transported mostly by ship (4 to 6 tanks for a total of 125000-160000 m3) • Methane (85-95%), ethane, propane + heavier hydrocarbons • It is kept at atmospheric pressure and refrigerated at about 111 K

  4. LNG hazards Besides “minor” damages (direct contact with cryogenic fluid, asphyxiation, breathing cold vapours), major hazards are: • Structural damage to tank/ship due to low T • Vapour cloud explosions (deflagration/detonation) • Vapour cloud fires • Pool fire • Rapid Phase Transition - RPT

  5. Rapid Phase Transition RPT • It is a fast expansion of vapour due to phase transition (phase change) • When vapour generation is very fast, localized overpressure can result • It can occur when cold LNG comes in contact with water at much higher (ambient!) temperature • It can be considered a physical explosion (no combustion)

  6. LNG release on water • LNG density is half that of water • LNG vapour density at boiling T is about 1.5 times the density of air • LNG will float on water • Pool spreading • More or less fast evaporation • A low-lying visible (moisture condensation) cloud will form

  7. Release dynamics A. Luketa-Hanlin /Journal ofHazardous Materials A132 (2006) 119—140

  8. Experimental data From past experimentation on LNG release on sea-water, for an RPT to occur it seems that: • A minimum CH4 content (40-80 %, depending on release size) is required; • Water temperature should be higher than 12/17°C (depending on degree of mixing with LNG) • RPT strength depends on spill rate (5 orders of magnitude increase over 0.3 m3/s)

  9. LNG composition LNG composition will affect vaporization dynamics: • Different boiling temperatures (vapour pressures): methane 111 K, C2 185 K, C3 231 K. • Different latent heats of vaporization Methane will boil off first Varying composition of the pool

  10. Uncertainties Among others (modelling, etc.): • Drake et al. (‘75), Boe (’98), etc.: • Heavier hydrocarbons will increase evaporation rate • Conrado & Vesovic (2000): • Heavier hydrocarbons will decrease evaporation rate

  11. Pool boiling Due to the temperature difference between LNG and water (about 180 °C) film boiling will result:

  12. Pool boiling • At high methane concentrations (initial stages): High temperature difference Film boiling / lower heat transfer rates (Vapour film acts as an insulator) • At later stages: Lower temperature difference Nucleate boiling / higher heat transfer rates (Very fast evaporation and RPT)

  13. RPT modelling Prevalent theory for RTP explosion is based on the superheat temperature TSH: TSH ( 170 K for methane; 326 K for propane) < Twater Source: SuperChemsExpert v5.7, ioMosaic Corp.

  14. RPT modelling Phase envelope for an LNG mixture Source: SuperChemsExpert v5.7, ioMosaic Corp.

  15. RPT modelling The propagation of blast wave may be reproduced by the acoustic analysis from conservation equations of mass and momentum: and by the definition of potential φ as:

  16. RPT modelling Under acoustic assumption: and in spherical coordinates for radius r: POTENTIAL WAVE EQUATION where co is the ambient speed of sound.

  17. RPT modelling The potential wave equation has been solved to give the peak overpressure P as a function of the distance R from the acoustic far-field source point (considering a ground explosion in open atmosphere) as: where g is the ratio of specific heats, co is the ambient speed of sound, R is the distance from source and Φ is the volume source strength (m3/s).

  18. RPT modelling Recently, van den Berg et al. (2004), have applied the correlation for blast wave produced by BLEVE modelling. For a vessel of volume V, if the flash fraction is F and the expansion ratio of liquid to vapour is , it can be written: integration

  19. Example of application These equations have been applied to LNG phase transition after release on sea level. Conservative option (worst-worst case analysis): V = 10000 m3 (Moss sphere) Time to release = 1 s – 10 s (instantaneous release) Flashing ratio F = 1 LNG composition = methane 100% liquid density ρ = 423 kg/m3 (at ambient temperature) vapour density ρ = 1.819 kg/m3 at boiling point vapour density ρ = 0.68 kg/m3 (at ambient temperature) expansion ratio  620

  20. Results Calculated acoustic RPT overpressure as a function of distance Dashed line: 0.08 bar = structural threshold value for atmospheric equipment Discharge time: Red = 1 s; Green = 10 s

  21. Results Acoustic model: max release time for reaching threshold values for overpressure Dashed lines: 0.08 and 0.3 bar Discharge time: Red = 2.75 s; Green = 5 s

  22. Results Acoustic model: overpressure profiles at different release time Dashed lines: 0.08 and 0.3 bar Discharge time: Red = 2 s; Green = 1 s

  23. Alternative model By adopting Brode’s equation with P1=24.6 bar (corresponding to TSH for methane), and P0=1.01 bar:

  24. Simulation results Release dynamics from a 27 m diameter tank, almost full ( 10000 m3) Catastrophic release

  25. Simulation results Release dynamics from a 27 m diameter tank, almost full ( 10000 m3) • 100 cm dia. hole • Hole level 2 m • Pin = 1.5 bar

  26. Simulation results Release dynamics from a 27 m diameter tank, almost full ( 10000 m3) • 100 cm dia. hole • Hole level 2 m • Pin = 1.5 bar

  27. Simulation results Release dynamics from a 27 m diameter tank, almost full ( 10000 m3) • 100 cm dia. hole • Hole level 2 m • No padding

  28. Simulation results Release dynamics from a 27 m diameter tank, almost full ( 10000 m3) • 100 cm dia. hole • Hole level 2 m • No padding

  29. Conclusions • LNG presents various sources of hazards • RPT explosions do not generate large distance impact areas • Thus RPTs don’t seem to represent a main hazard to public safety • However, they still can generate further damages close to the spill location, due to: • Brittle fracture • Thermal effects • Overpressure

  30. References • W.E. Baker, P.A. Cox, P.S. Westine, J.J. Kulesz, R.A. Strehlow, Explosion hazards and evaluation, Elsevier, Amsterdam, 1983. • G.B. Whitham, On the propagation of weak shock waves, Journal of Fluid Mechanics 1 (1956) 290. • A.C. van den Berg , M.M. van der Voort, J. Weerheijm, N.H.A. Versloot Expansion-controlled evaporation: a safe approach to BLEVE blast, Journal of Loss Prevention in the Process Industries 17 (2004) 397–405 • Lighthill, J.(1978). Waves in fluids.Cambridge : Cambridge University Press. • Reid, R.C.(1976).Superheated liquids. American Scientist, 64, 146–156. • Reid, R.C.(1979). Possible mechanisms for pressurized-liquid tank explosions or BLEVE’s. Science, 203, 3. • Strehlow, R.A. (1981).Blast wave from deflagrative explosions: an acoustic approach. 13th AIChE loss prevention symposium, Philadelphia (PA). • A. Luketa-Hanlin, A review of large-scale LNG spills: Experiments and modeling, Journal of Hazardous Materials A132 (2006) 119–140 • C. Conrado, V. Vesovic, The influence of chemical composition on vaporization of LNG and LPG on unconfined water surfaces, Chem. Eng. Sci. 5 (2000) 4549–4562.

  31. Thank you for your attention

More Related