1 / 12

Building the 5.5 HP Tecumseh

Building the 5.5 HP Tecumseh. Cylinder Head, Push Rods , Rocker Arms , Valves. What are the 4 steps of combustion?. 1. INTAKE 2. COMPRESSION 3. SPARK 4. EXHAUST. The 4 Steps of Combustion. Crankshaft. Add The Head Gasket. Make sure the holes line up correctly. Cylinder Head.

oralee
Download Presentation

Building the 5.5 HP Tecumseh

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Building the 5.5 HP Tecumseh Cylinder Head, Push Rods, Rocker Arms, Valves

  2. What are the 4 steps of combustion? • 1. INTAKE • 2. COMPRESSION • 3. SPARK • 4. EXHAUST

  3. The 4 Steps of Combustion

  4. Crankshaft

  5. Add The Head Gasket • Make sure the holes line up correctly

  6. Cylinder Head • 1. Put on bolt through the cylinder head AND gasket to make sure the holes line up correctly • 2. Use the 5 bolts and tighten the cylinder head down until snug

  7. Lifting Rods • 1. Place the two lifters into the oval holes as shown. • 2. They should both be at the same height! • 3. DO NOT LET THE LEFT ONE FALL INTO THE CRANKCASE!

  8. The Rocker Arms • 1. Align the retaining clip over the holes in the cylinder head. • 2. Place the Rocker Arm over top and tighten down the Rocker Arm Stud

  9. Valve Cover • 1. Place the valve cover over the cylinder head and align with the holes. • 2. Align the engine lifting bracket with the holes as well. • 3. Tighten down the 4 bolts till snug.

  10. Knock Sensor • 1. Align the Knock Sensor over the gasket and bolt into place using a torq or “star” bit. • 2. Feed the end of the wire through the block as shown.

  11. The 4 Steps of Combustion

  12. HI FIVE! • YOU’VE COMPLETED THE 2ND MOST DIFFICULT PART OF THE ENGNE BUILD!! THE TOP END!!!

More Related