1 / 6

face 1

face 1. face 5. face 2. face 4. face 3. point 3. point 5. point 1. point 2. point 6. point 4. You are to add GDT (by hand) to the blank drawing as follows (see page 2 of the PowerPoint file which labels the faces and points referred to):

rafal
Download Presentation

face 1

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. face 1 face 5 face 2 face 4 face 3 point 3 point 5 point 1 point 2 point 6 point 4

  2. You are to add GDT (by hand) to the blank drawing as follows (see page 2 of the PowerPoint file which labels the faces and points referred to): The principal datum is to be face 1. This face should be machined so that it has a smoothness of .005". The secondary datum is the axis along the .75" diameter cylinder. The cylinder must be machined so that its diameter is within plus or minus .008" of .75" and its center axis meets a perpendicularity tolerance of diameter .005" relative to datum A, regardless of feature size. The tertiary datum is face 2. This face should be machined so that it meets a perpendicularity tolerance of .0075" relative to datums A and B. The four holes should meet a position tolerance of a diameter of .025" at maximum material condition. The diameters of these holes should be within plus or minus .005" of .20".

  3. The profile of the slot between points 1 and 2 must be within a tolerance zone of .002". Face 3 must meet a perpendicularity tolerance of .01" relative to datums A, B, and C. The outer edges of the front face between points 3 and 4 must meet a profile tolerance of .05". The length of the .75" diameter cylinder must be within plus or minus .01" of 1". Faces 4 and 5 must meet a perpendicularity tolerance of .05" relative to datumsA, B, and C.

More Related