1 / 20

Electrical Engineering Lab I - Safety Guidelines and Equipment Instructions

Familiarize yourself with lab safety rules, equipment usage, and report guidelines for EECE 1101. Be prepared, tidy, and ready for hands-on experiments.

rlongoria
Download Presentation

Electrical Engineering Lab I - Safety Guidelines and Equipment Instructions

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. EECE 1101 Electrical Engineering Lab I

  2. Taaruf • Nor FarahidahZa’bah • Room number : E2-2-13.12 • Phone number : 03-61964562 • Email address : adah510@iium.edu.my • The lab technician is • Br. Ahmad SuhairiMohd. Jebah • The lab demonstrator is • Br. Akhter • Course website: • http://staff.iium.edu.my/adah510

  3. Assessment

  4. Safety • Please wear covered shoes – NO SLIPPER. Otherwise, you will be asked to leave the lab. • Power must be switched off whenever an experiment or project is being assembled, disassembled, or modified.

  5. Tidiness • When the experiment has been satisfactory completed and the results approved by the instructor, the students may disconnect the circuit and return the components and instruments to the locker tidily. • Chairs are to be slid in properly. • DO NOT WRITE anything on the table

  6. Preparation • Read the entire experiment and research any required theory beforehand. Many times an experiment takes longer that one class period simply because a student is not well prepared. • The experiment is performed in pairs (max=3 students per group) but the final exam is performed individually • One group = one lab report

  7. Lab Reports • Reports have to be handwritten for submission. • Writing should appear on one side of each sheet only. • The students’ name & matric number, section number, lab session and the lecturer’s • Please indicate the author of each section in your report. • The cover page of the lab report can be downloaded from the website.

  8. Report Format and Evaluation

  9. Preparation for PSPICE Tutorial • Download 16.6_OrCAD_Lite_Capture&PSpice_Products.zip from the any computer in the lab • It is a zipped file, you have to extract the files into a designated folder • Once you have extracted, go to Disk 1 and look for SETUP (it is an application file) to install the software. • One group will require ONE laptop for the tutorial sessions

  10. Introduction to Lab Equipment • Bread board and its connections Holes that are labelled with letters means SAME node

  11. Function Generator • To create AC signals such as Sine-Wave, Triangular Waves and Square Wave • The user can alter its frequency and amplitude Example of a function generator

  12. Oscilloscope • An equipment to show the obtained result. • Has 2 channels • One for input signal • One for output signal

  13. DC power supply • To provide DC supply to your circuit which you can measure using digital multi-meter

  14. Digital Multimeter (DMM) • To measure voltage, turn the knob to DC Volts • The DMM is place ACROSS/IN PARALLEL with the device • To measure current, turn the knob to AC (mA) • The lead is place IN SERIES with the device Main reason why DMM failed to work as Ammeter is because students tend to short circuit the two leads.

  15. A B SERIES GND PARALLEL

More Related