1 / 11

Lab # ___ Transpiration

Lab # ___ Transpiration. Text Pages: 746-748. Procedure I. Attach the water-filled syringe to the small tubing. Prime the potometer by adding water ( slowly ) with the syringe until the level of the water forms a bead on the top of the longer tubing side.

rozene
Download Presentation

Lab # ___ Transpiration

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Lab # ___ Transpiration Text Pages: 746-748

  2. Procedure I • Attach the water-filled syringe to the small tubing. • Prime the potometer by adding water (slowly) with the syringe until the level of the water forms a bead on the top of the longer tubing side. ***check to insure that the tubing side is about ½ the distance up the pipet side. • Using the scissors, gently cut a tapered plant stem form the plant. Try to find a stem that would fit snugly & firmly into the tubing side of the stem. • Insert the cut stem into the tubing. • Remember: you want an air-tight system so make sure that there are no air bubbles present. • Dry the area at the base of the stem near the tubing • Seal the area with petroleum jelly. (Hypothesis??)

  3. Procedure II • Allow the potometer to equilibrate for 5 minutes. Note: the level will go down and should slowly stop. • Once it is equilibrated, gently press the plunger of the syringe until the water level reaches zero on the pipet. If it leaks add more jelly and start at a lower level on the pipet for your initial reading. • Record your initial reading (0 ml) and monitor the potometer and record your data every 5 minutes for 30 minutes. • We will discuss the theory behind transpiration and begin our discussion on photosynthesis. • Discuss: -Leaf surface area determination (2 ways) -Sources of Error

  4. Determining Transpiration Rate • At the end of the experiment cut off all the leaves from your stem, blot off excess water and take the mass of the leaves. • Mass of all the leaves: g • Two ways to figure out the surface area: • Leaf trace method with graph paper • Leaf mass method (we will do) • Cut a 1 cm2 section from one of the leaves. • Take the mass of this section: g • Multiply the section’s mass by 10,000 to convert to m2. Leaf surface area; m2 • Divide the total mass of leaves (grams) by the mass per square meter to determine the leaf surface area • Record the value: m2

  5. Determining Transpiration Rate II • Calculate the water loss per square meter of leaf surface area by dividing the water loss at each 5 minute reading by the surface area you calculated. • Place your calculated values in a table. • Water loss at 0, 5, 10, 15, 20, 25, 30 (lab data) • Water loss per m2 at same intervals • Overall class averages will be determined.

  6. Data Collection & Organization • Plant species: • Table I: All five conditions and 5 minute intervals • Mass of all leaves: g • Mass of 1 cm2 section: g Mass of all leaves (g) x 1 cm2 x (1 m 2) = mass of section (g) (104 cm) • Total Leaf surface area: m2 • Table II: Water loss Cumulative water loss / m2 for each condition Transpiration rate water loss/ m2 / minute • Plot & Graph all five conditions

  7. Analysis & Conclusion • Do Question #1-5. Be sure to include the vacuum condition to all responses • On the back: Briefly state if your hypothesis is supported by this data or not and comment on sources of error that could have been a factor.

  8. Suggested Data Table (p. 1)

  9. Suggested Data Table (p. 2)

  10. Suggested Data Table (p. 5)

  11. Suggested Data Table (p. 6)

More Related