1 / 28

Combined Cycle Power Plants

Combined Cycle Power Plants. P M V Subbarao Professor Mechanical Engineering Department. Better Use of Energy resources…. More Entropy Vehicles for Better Success. Fuel Power. Waste Heat. Energy Flow in Combined Cycle. Final Waste heat. Thermal Analysis of Combined Cycle.

sbacon
Download Presentation

Combined Cycle Power Plants

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Combined Cycle Power Plants P M V Subbarao Professor Mechanical Engineering Department Better Use of Energy resources….

  2. More Entropy Vehicles for Better Success

  3. Fuel Power Waste Heat Energy Flow in Combined Cycle Final Waste heat

  4. Thermal Analysis of Combined Cycle Net Power Output of Gas Cycle: Rate of Heat Rejection in Gas Cycle: Rate of Heat input to steam Cycle: Net Power Output of Steam Cycle:

  5. Net Power Output of Sandwich: Overall Efficiency of Sandwich:

  6. Law of Combination

  7. COMBINED CYCLE POWER PLANT GAS INLET P=10bar CC T=1500C T=8500C P=10bar TURBINE G COMP T=1000C T=500C STACK P=2bar P=1bar T=5500C HP IP LP AIR INLET HRSG T=5000C P=170bar TURBINE T=500C G PUMP P=1bar P=.1 bar T=500C T=600C CONDENSER

  8. Cogeneration Plants

  9. Types of HRSG • Basic types of standard design of heat recovery steam generators are differentiated by the direction of the flue gases flow. • Vertical HRSG • Small footprint • Simple concept of service • Hanging design of heating surfaces • Horizontal HRSG • Small construction height • High cycling ability • Operational flexibility • Hanging design of heating surfaces

  10. Vertical HRSG

  11. Horizontal HRSG Vertical HRSG

  12. Heat Exchanging Curve ~5500C ~1000C ~400C

  13. HRSG COMPONENTS

  14. Types of Evaporator Sections • D-Frame evaporator layout • O-Frame evaporator layout • A-Frame evaporator layout • I-Frame evaporator layout • Horizontal tube evaporator layout

  15. D-Frame evaporator layout • This configuration is very popular for HRSG units recovering heat from small gas turbines and diesel engines. • It is a very compact design and can be shipped totally assembled. • Main Drawback: The bent tube arrangement quickly causes the module to exceed shipping limitations for units having a large gas flow

  16. O-Frame evaporator layout • This configuration has probably been used for more years than any of the others. • It has the advantage of the upper header being configured as the steam separation drum. • Alternately, The upper header can be connected to the steam drum by risers. • This allows more than one O-Frame evaporator to be connected to the same steam drum. • Results in shipable modules being able to handle very large gas flows.

  17. A-Frame evaporator layout • This configuration is simply a variation of the O-Frame Evaporator. • It was popular for services with a large amount of ash, since the center area between the lower drums could be configured as a hopper to collect and remove solid particles.

  18. I-Frame evaporator layout • In the past twenty years, this configuration has become the most popular. • This type module can be built in multiple axial modules or in multiple lateral modules, allowing it to be designed to accept any gas flow. • There are numerous variations of this design where tube bundles may contain one, two, or three rows of tubes per header. • It is also, normally, more economical to manufacture, ship and field construct. • The tube bundles may be shipped to field installed in the modules, or as loose bundles which are installed into a field erected shell.

  19. Horizontal tube evaporator layout The horizontal tube evaporator is used, not only for heat recovery from Gas Turbine exhaust, but for recovery from flue gases in Refinery and Petrochemical furnaces also. • It has similar size limitations due to shipping restrictions similar to the O-frame modules. • It is generally a less expensive unit to manufacture than the other configurations.

  20. Schematic Diagram of a Simple HRSG ~1000C ~5500C

  21. Single Pressure Rankine Cycle ~5500C ~1000C ~400C

  22. Dual Pressure Rankine Cycle

  23. Triple Pressure Rankine Cycle

  24. Layout of Triple Pressure Rankine Cycle

  25. Calculated Values of HRSG Modules In A 101MW CCPP

  26. Today’s Limits • Limits are, in this case, meant to be state of the art values of key performance factors of a HRSG application • limits driven by economical and technical considerations. • Triple Pressure Reheat Drum Type Boilers, natural circulation:

More Related