1 / 11

Configuring Retro-reflective Photo Sensor with RS Logix

Learn how to configure a retro-reflective photo sensor using RS Logix software. Follow step-by-step instructions to assign a new address to the sensor device.

beeksj
Download Presentation

Configuring Retro-reflective Photo Sensor with RS Logix

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Steps To Configure One Sensor Gary Tipton

  2. The Hardware: • Retro-reflective Photo Sensor

  3. Actual Sensor

  4. Device Box

  5. To Configure the sensor: • Open up RS Logix software and select Device Net. • Perform a scan of the system to see if the system recognizes any items in it’s network. • After the device has been observed by the master, than a new address could be assigned to the device.

  6. A better look:

  7. Screen shot

  8. A New Address: • Right click on the device that you want to give a new address to. • Select properties • The device information can be manipulated from there. • Re-scan to ensure the new address takes

  9. Properties

  10. Name and Address

  11. Re-Scan

More Related